CASMED 740 Vital Signs Monitor - Implox

CASMED 740 Monitors
MAP VALUE ENABLE / DISABLE
During a blood pressure reading, the user can elect to display or not to display the MAP value.
Should it need to be changed, first enter the Configuration menu. Refer to Page 98, ENTERING
THE CONFIGURATION MENU.
Once in the menu, use one of the NEXT programmed pushbutton keys until the Message
Window displays the monitor’s current setting for the MAP value “MAP On” or “MAP Off”.
Use the ARROW UP or ARROW DOWN pushbuttons to make your selection.
NOTE:
When “MAP Off” is selected, MAP values are omitted from History Display and Printing as well.
All alarms associated with MAP values are also disabled.
Press one of the NEXT programmed pushbutton keys to advance onto the next menu or use the
CANCEL pushbutton to exit to the “Ready” mode.
SET THE SpO 2 ALARM DELAY
The delay time until an alarm is generated for %SpO 2 and Pulse Rate can be configured to be
either zero (0) seconds “Delay 0S” or ten (10) seconds “Delay10S”. The default value used by
the Model 740 Monitor is ten (10) seconds.
Should it need to be changed, first enter the Configuration menu. Refer to Page 98, ENTERING
THE CONFIGURATION MENU.
Once in the menu, use one of the NEXT programmed pushbutton keys until the Message
Window displays the monitor’s current setting for the SpO 2 Alarm Delay.
Use the ARROW UP or ARROW DOWN pushbuttons to make your selection.
Press one of the NEXT programmed pushbutton keys to advance onto the next menu or use the
CANCEL pushbutton to exit to the “Ready” mode.
21-02-0298 REV. 00 12/06
103