OFFICIAL BID SHEET BID NUMBER: 12-39 FIRM CONTRACT ...

More documents

Recommendations

Info

film thicknesses and a list of five projects where each product has been used and rendered satisfactory service. No request for substitution shall be considered that would decrease film thickness or offer a change in the generic type of coating or flooring specified. Bidders desiring to use coatings and flooring other than those specified shall submit those with their proposal based on the specified materials, together with the information from above and indicate the sum which will be added to or deducted from the base bid should alternate materials be accepted. Products for each specified function and system shall be of a single manufacturer. Materials Tnemec Series 237 Power-Tread epoxy primer and basecoat. Tnemec Series 280 Tneme-Glaze epoxy intermediate coat. Material Preparation Mix materials according to manufacturer's latest printed instructions paying particular attention to mixing times and temperatures. Do not use materials beyond manufacturer's recommended pot life or shelf life. Pre-work Inspection Examine surfaces to be coated and report conditions that would adversely affect appearance or performance of systems and which cannot be put into an acceptable condition by preparatory work as specified. Surface Preparation Concrete/Tile Floors: Allow new concrete to cure for 28 days. Mechanically shotblast floor to remove all laitance, curing compounds, and surface contaminants, and to provide a uniform minimum surface profile of a CSP 3-5 as noted in ICRI Guideline 03732. Fill all bugholes and cracks with a recommended surfacer. After shotblasting, verify that all surfaces are clean, dry and free of any contaminants that could adversely affect the adhesion of the flooring system as detailed in SSPC-SP 13/NACE No. 6 Application Materials shall be mixed and applied according to manufacturer's latest printed instructions. Apply a 4” rolled radius cove base at all walls for thin film system unless indicated otherwise on drawings. Allow flooring systems to cure fully in accordance with manufacturer's instructions prior to allowing traffic. 6
Inspection • Surface preparation prior to applying any floor coatings. • Completed flooring system application. Cleaning Keep areas clean of excess materials and rubbish during and after application. Remove all spatters from surrounding equipment and substrates, and leave area in neat and clean condition Finish Schedule Thin Film Pigmented Flooring System Cove Base Primer Tnemec Series 237 Power-Tread 6.0 to 8.0 mils Cove Base Tnemec Series 237 Power-Tread 1/8”minimum applied 1st Coat Tnemec Series 237 Power-Tread 6.0 to 8.0 mils 2nd Coat Tnemec Series 280 Tneme-Glaze* 8.0 to 10.0 mils 3rd Coat Tnemec Series 280 Tneme-Glaze 8.0 to 10.0 mils * Broadcast sand into second coat at a rate of 2 lbs per 100 square feet if specified for a non-skid finish. 7
Page 1 and 2: OFFICIAL BID SHEET BID NUMBER: 12-3
Page 3 and 4: Reservation This IFB does not commi
Page 5: FLOOR PREPARATION AND INSTALLATION
Page 9 and 10: If bid amount exceeds $20,000.00 a
Page 11 and 12: HENDERSON STATE UNIVERSITY Purchasi
Page 13 and 14: CONTRACT AND GRANT DISCLOSURE AND C

OFFICIAL BID SHEET BID NUMBER: 12-39 FIRM CONTRACT ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?