Download - Herion Systemtechnik GmbH

Instructions for electrical installation
1. Voltage supply
Voltage supply 18 ... 32 V (incl. residual ripple.)
Excess voltage may destroy the electronic system!
2. Avoidance of interferences
2.1 Screening
In order to prevent interferences by electric fields,
screened lines must be used. The screen must be
connected to PE (see circuit diagram).
General
Transport, storage, default setting, cleaning
The product can only be transported and stored in the
original Herion packaging which ensures suitable
protection against mechanical damage.
The product is shipped in a ready-to-operate-state
(default settings). After correct installation, it is ready
for use.
In case it is necessary to clean porduct, we recommend
sending it back to the manufacturer.
2.2 Laying of cables
Supply and signalling lines shall not be laid in parallel to
power mains or high-voltage lines.
3. Line cross section
According to VDE 01134.
Zero potentials
For zero potentials (0 V), the supply voltage and the
setpoint signal, two separate wires must be used in
order to prevent distortion of the setpoints.
8 Subject to alteration
7502961.06.02.06