Unit 4.54905 - Harken

More documents

Recommendations

Info

ASSEMBLY Foils ■ ASSEMBLE FOIL Make sure you have drilled a hole in the top foil so it lines up with the hole tapped in the trim cap. Slide top foil to top of stay, screw holes towards the bottom. TIP: When working with rod, tape lower connectors in place or use a pusher wire longer than foil to hold connectors. Coat the trim cap top bushing with red Loctite. Place a wedge in the indentation and insert into the top foil. Coat a foil screw with red Loctite. Thread into connector hole. Slide first connector to the top of the stay. Coat half of the connector and the indentation with red Loctite. Place a plastic connector wedge in the indentation closest to the top foil. 10 Hydraulic Furling 4.5 April 2000
ASSEMBLY Foils Coat three foil screws with red Loctite. Screw them into the connector until tight. Continue assembly. Slide halyard swivel onto foil, tall end up. Install feeder screws toward bottom, using red Loctite on screws. Slide torque tube onto foils. April 2000 Hydraulic Furling 4.5 11
Page 1 and 2: Hydraulic Furling Installation Manu
Page 3 and 4: GENERAL SPECIFICATIONS Unit 4.5 ■
Page 5 and 6: GENERAL SPECIFICATIONS Parts List
Page 7 and 8: PREPARATION Headstay Length ■ HEA
Page 9: PREPARATION Cutting Top Foil ■ NO
Page 13 and 14: ASSEMBLY Attach Stay - Wire ■ ATT
Page 15 and 16: ASSEMBLY Torque Tube ■ INSTALL TO
Page 17 and 18: ASSEMBLY Raise Furling • Gearbox
Page 19 and 20: ADJUSTMENTS Headstay Tension ■ AD
Page 21 and 22: ADJUSTMENTS Pendants ■ PENDANTS I
Page 23 and 24: ADJUSTMENTS Before Operation • Ma

Unit 4.54905 - Harken

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?