HAHN+KOLB-Toolcatalog 2011/12 – Metal Cutting Tools

Metal-cutting tools
Milling tools
End mills HSSE
Continued next page
NC automation identifying tool 'WriteStar'
for process-integrated marking of parts
The WriteStar inscription tool is suitable for applying permanent identifications in many different materials
with a hardness of up to 60 HRC. The inscription is applied with a special pen based on a combination of
material compression and material displacement. Since neither fluid supply nor speed are required for the
use of the WriteStar, this tool is suitable for use with most CNC machines and also robots. The inscription
can be applied during the machining sequence of a workpiece. Unclamping and clamping on an inscription
base and unclamping after applying the inscription are not required. In addition, inscription machines and
the related expenditure, time and costs are therefore not required. The tool can be loaded by means of the
tool changer and set and programmed in the same way as a conventional cutting tool. The use of the
machine under normal operating conditions in daily practice has shown that the special needle usually has
a service life between 2 and 5 years without the need for regrinding.
Application range:
•suitable for applying inscriptions on smooth surfaces with a hardness of up to 60 HRC
•suitable for applying inscriptions on uneven cast surfaces up to 5 mm
•suitable for applying inscriptions on convex surfaces (up to 5 mm)
h Other information see No. 16531 page 305.
Product video:
use your mobile phone to scan the QR code.
Continued next page
Engraving cutter HSSE
Z
1
HA
Execution: form A, half-round shank, section pre-ground for adapting to the material to be machined.
d1
l2
l1
Ø d1 mm 2,5 4 6 8 10 12
Length l2 mm 4 6 9 12 12 15 18
Length l1 mm 40 60 80 90 125 125 125
15005 Ident. No. 025 040 060 080 083 100 120
Unit price E O. R. O. R. O. R. O. R. O. R. O. R. O. R.
h Solid carbide engraving cutter see No. 16564 page 305.
i HSSE/HSSE-PM end mills selection overview page 230.
Prod. Gr. 106
Continued next page
Single tooth milling cutters HSSE (5 % Co)
type W
RH cut
Z
1
Execution: HSSE, finishing teeth, straight shank in conformity with DIN 1835 A.
HA
d1
l2
l1
d2
Ø d1 js 14 mm 3 4 5 6 7 8 9 10 12
Cutter length I2 mm 12 12 14 14 14 14 14 14 14
Overall length I1 mm 60 60 60 60 60 80 80 80 80
Shank Ø d2 h6 mm 8 8 8 8 8 8 8 8 8
15007 Ident. No. 030 040 050 060 070 080 090 100 120
Unit price E O. R. O. R. O. R. O. R. O. R. O. R. O. R. O. R. O. R.
Application Steel (N/mm²) Stainless st. Aluminium Brass Bronze Plastics Graphite/ Gray cast Ti Ni Super