HAHN+KOLB-Toolcatalog 2011/12 – Metal Cutting Tools

Continued next page
Hand reamers HSS
from Ø 8 mm slotted
Reaming tools
Hand reamers
DIN 859
RH cut
Metal-cutting tools
7–8°
Execution: shape B with left hand spiral 7 –8°, with guide and with check nut.
The reamers are ground to the standard measure, but not the tolerance H 7. The tolerance H 7 will be supplied
on order. Diameters below 6 and above 30 mm are not standardised.The adjustability lies within the
elasticity limit of hardened steel and is approx. 1 /100 of diameter. These reamers are to be stored only in
slack state.
Ø mm 6 7 8 9 10 11 12 13 14 15 16
Overall length mm 93 107 115 124 133 142 152 152 163 163 175
Flute length mm 47 54 58 62 66 71 76 76 81 81 87
Shank square mm 4,5 5,6 6,3 7,1 8 9 10 10 11,2 11,2 12,5
11606 Ident. No. 060 070 080 090 100 110 120 130 140 150 160
Unit price E O. R. O. R. O. R. O. R. O. R. O. R. O. R. O. R. O. R. O. R. O. R.
Ø mm 17 18 19 20 22 24 25 26 28 30
Overall length mm 175 188 188 201 215 231 231 231 247 247
Flute length mm 87 93 93 100 107 115 115 115 124 124
Shank square mm 12,5 14 14 16 18 20 20 20 22,4 22,4
11606 Ident. No. 170 180 190 200 220 240 250 260 280 300
Unit price E O. R. O. R. O. R. O. R. O. R. O. R. O. R. (O. R.) O. R. O. R.
Application Steel (N/mm²) Stainless st. Aluminium Brass Bronze Plastics Graphite/ Gray cast Ti Ni Super