eAFK - Oerlikon Barmag - Oerlikon Textile
eAFK - Oerlikon Barmag - Oerlikon Textile
eAFK - Oerlikon Barmag - Oerlikon Textile
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>eAFK</strong> coolfl ex: V 1.5 DT/ 0.8 T<br />
The coolfl ex upper structure is optimized for processing very fi ne denier or products with very low fi lament count by means<br />
of a shorter Dowtherm heater in combination with a 0.8 m cooling tube. The 1.5 m heater allows energy savings of up to<br />
15% in comparison to the 2.0 m version. The 0.8 m cooling tube provides increased cooling capacity on shorter length and<br />
can be further optimized according to product requirement by adjusting the wrapping angle. This results in an operational<br />
window that especially favors fi ne denier and allows to process products even down to 20 den at even higher process<br />
speeds than the standard cross section.<br />
Improved processing of very fi ne and micro yarns is<br />
achieved by...<br />
–<br />
–<br />
–<br />
–<br />
optimized heater length<br />
improved and fl exible cooling<br />
shortest possible texturing zone<br />
less stress to yarn with selected components<br />
Suitable for super micro fi lament yarns and very fi ne to fi ne<br />
denier, opening operational window for these products while<br />
contributing energy saving<br />
<strong>eAFK</strong> Multispindle: V 2.0 DT/ 1.1 P x 2<br />
The Multispindle upper structure allows processing double the number of yarn ends for production of non-torque yarns in a<br />
product range of fi ne to mid denier with low to conventional fi lament count. While plying yarns on conventional machines the<br />
take-up capacity is reduced by half, thus increasing the number of yarn ends for treatment before being plied doubles the<br />
take-up capacity. Prerequisite for such processing is the limitation of single yarn ends to 220 den considering the fi nal denier<br />
of the plied yarn. This results in an operational window that favors fi ne to mid denier including low single fi lament yarns.<br />
Improved processing of plied fi ne to mid denier yarns is<br />
achieved by…<br />
–<br />
–<br />
–<br />
doubling the number of yarn ends per heater<br />
doubling the number of cooling plates<br />
doubling the number of texturing positions<br />
Suitable for micro fi lament yarns and fi ne to mid denier,<br />
opening operational window for plied products<br />
<strong>eAFK</strong> – <strong>Oerlikon</strong> <strong>Barmag</strong><br />
21
Change language