ÇUKUROVA UNIVERSITY INSTITUTE OF NATURAL AND APPLIED ...
ÇUKUROVA UNIVERSITY INSTITUTE OF NATURAL AND APPLIED ... ÇUKUROVA UNIVERSITY INSTITUTE OF NATURAL AND APPLIED ...
5. SIMULATION RESULTS AND CASE STUDIES Mustafa İNCİ RMS characteristics of Phase A, Phase B and Phase C voltages are seen in Figure 5.7 when single phase voltage sag occurs on Phase C. Figure 5.7. RMS Characterisics for Case 1 5.2.1.2. Case 2: Two Phase Voltage Sag A and B phase source voltage decreases to 70% from its nominal value during the period of 0.3-0.4 s. In A and B phases, phase jump occurs between source-side and load-side voltages. DVR operation for double line to ground fault is 91
5. SIMULATION RESULTS AND CASE STUDIES Mustafa İNCİ seen in Figure 5.18. Figure 5.8 (a) and 5.8 (b) show the simulation results of sourceside voltages and injected voltages under double-phase to ground fault. The load voltage is maintained at the desired 1 p.u. as shown in Figure 5.8 (c). Figure 5.8. Simulation results for Case 2 DC link capacitor voltage is kept at reference value (1.7 kV) by DC-DC Converter. DC link capacitor voltage (V cap ) varies between 1.627-1.651 kV band 92
- Page 61 and 62: 3. FUNDAMENTALS OF DVR Mustafa İNC
- Page 63: 3. FUNDAMENTALS OF DVR Mustafa İNC
- Page 66 and 67: 4. MODELING OF PROPOSED DVR Mustafa
- Page 68 and 69: 4. MODELING OF PROPOSED DVR Mustafa
- Page 70 and 71: 4. MODELING OF PROPOSED DVR Mustafa
- Page 72 and 73: 4. MODELING OF PROPOSED DVR Mustafa
- Page 74 and 75: 4. MODELING OF PROPOSED DVR Mustafa
- Page 76 and 77: 4. MODELING OF PROPOSED DVR Mustafa
- Page 78 and 79: 4. MODELING OF PROPOSED DVR Mustafa
- Page 81 and 82: 4. MODELING OF PROPOSED DVR Mustafa
- Page 83 and 84: 4. MODELING OF PROPOSED DVR Mustafa
- Page 85 and 86: 4. MODELING OF PROPOSED DVR Mustafa
- Page 88 and 89: 4. MODELING OF PROPOSED DVR Mustafa
- Page 90 and 91: 4. MODELING OF PROPOSED DVR Mustafa
- Page 92: 4. MODELING OF PROPOSED DVR Mustafa
- Page 95 and 96: 4. MODELING OF PROPOSED DVR Mustafa
- Page 97 and 98: 4. MODELING OF PROPOSED DVR Mustafa
- Page 100 and 101: 4. MODELING OF PROPOSED DVR Mustafa
- Page 102 and 103: 5. SIMULATION RESULTS AND CASE STUD
- Page 104 and 105: 5. SIMULATION RESULTS AND CASE STUD
- Page 106 and 107: 5. SIMULATION RESULTS AND CASE STUD
- Page 108 and 109: 5. SIMULATION RESULTS AND CASE STUD
- Page 112 and 113: 5. SIMULATION RESULTS AND CASE STUD
- Page 114 and 115: 5. SIMULATION RESULTS AND CASE STUD
- Page 116 and 117: 5. SIMULATION RESULTS AND CASE STUD
- Page 118 and 119: 5. SIMULATION RESULTS AND CASE STUD
- Page 120 and 121: 5. SIMULATION RESULTS AND CASE STUD
- Page 122 and 123: 5. SIMULATION RESULTS AND CASE STUD
- Page 124 and 125: 5. SIMULATION RESULTS AND CASE STUD
- Page 126 and 127: 5. SIMULATION RESULTS AND CASE STUD
- Page 128 and 129: 6. CONCLUSION Mustafa İNCİ 6. CON
- Page 130 and 131: 6. CONCLUSION Mustafa İNCİ • En
- Page 132 and 133: DELFINO, B., FORNARI, F., PROCOPIO,
- Page 134 and 135: KARIMI-GHARTEMANI M., IRAVANI M.R.
- Page 136 and 137: OĞUZ, G., 2004. Performance Of A D
- Page 138 and 139: TESTA A., AKRAM M.F., BURCH R., CAR
- Page 140 and 141: BIOGRAPHY Mustafa İNCİ was born i
- Page 142 and 143: APPENDIX 123
- Page 144 and 145: LIST OF PUBLICATIONS International
5. SIMULATION RESULTS <strong>AND</strong> CASE STUDIES Mustafa İNCİ<br />
seen in Figure 5.18. Figure 5.8 (a) and 5.8 (b) show the simulation results of sourceside<br />
voltages and injected voltages under double-phase to ground fault. The load<br />
voltage is maintained at the desired 1 p.u. as shown in Figure 5.8 (c).<br />
Figure 5.8. Simulation results for Case 2<br />
DC link capacitor voltage is kept at reference value (1.7 kV) by DC-DC<br />
Converter. DC link capacitor voltage (V cap ) varies between 1.627-1.651 kV band<br />
92
Change language