LANTEK User Manual - Ideal Industries
LANTEK User Manual - Ideal Industries
LANTEK User Manual - Ideal Industries
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2<br />
Test Setup Procedures<br />
TONE GENERATOR<br />
Both the Display Handset and Remote Handset can generate a “low” tone, “high” tone,<br />
or “warble” tone (alternating “low” and “high” tone at 2 Hz rate) that is detectable by<br />
most standard wire tracing amplifiers.<br />
Figure 2-24: Typical Tone Generator Setup<br />
Note: The WIREMAP, SHIFT, and TONE buttons are hard keys. Pair A, Pair B, Pair C,<br />
Pair D, Low, High, and Warble are soft keys that appear on the Display Handset.<br />
ACTIVATING THE TONE GENERATOR USING THE DH<br />
1. Connect the Display Handset to the cable under test.<br />
2. Press WIRE MAP to enter Tone mode.<br />
Note: The Tone mode will remain active until ESCAPE is pressed.<br />
3. Using the soft keys, select the pair (Pair 78, Pair 36, Pair 54, or Pair 12) on which<br />
to place the tone.<br />
4. Select the tone, press SHIFT, and select LOW, HIGH, or WARBLE using the soft<br />
keys.<br />
2-19
Change language