LANTEK User Manual - Ideal Industries
LANTEK User Manual - Ideal Industries
LANTEK User Manual - Ideal Industries
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2<br />
Test Setup Procedures<br />
3. Press ENTER to save or ESCAPE to exit.<br />
Note: Refer to the following conversion for differences in measurement units:<br />
1 meter = 3.28084 ft<br />
1 foot = 0.3048006 m<br />
BAUD RATE<br />
When using the RS-232 serial port, this option can configure the baud rate at which<br />
information will be transmitted.<br />
1. Select Baud Rate on the Preferences screen. Press ENTER. The Baud Rate screen<br />
appears.<br />
Figure 2-7: Baud Rate Screen<br />
2. Select or to choose the desired setting.<br />
3. Press ENTER to save or ESCAPE to exit.<br />
TALKSET<br />
<strong>LANTEK</strong> testers are “Talkset ready.” Use this option to configure communications<br />
between the Display Handset and the Remote Handset through an externally attached<br />
microphone/headset.<br />
To talk with someone using the talkset, both the Display Handset and the Remote<br />
Handset must be connected to a cable.<br />
If the Talkset is set to “Auto,” the Talkset feature is automatically enabled when<br />
Autotest is not running. If the Talkset is set to “<strong>Manual</strong>,” the TALK button must be<br />
pressed momentarily to enable the Talkset feature.<br />
The units will remain in “Talk” mode until the ESCAPE button on either unit is<br />
pressed, the AUTOTEST button is pressed, or after a period of no talk activity is<br />
detected by the Display Handset.<br />
1. Select Talkset on the Preferences screen. Press ENTER. The Talkset screen<br />
appears.<br />
2. Press the ARROW keys to highlight the desired setting.<br />
3. The default setting for Talkset is “<strong>Manual</strong>”. Select or to select the<br />
desired setting.<br />
2-5