Heatlock ESB2, Electric Sprue Bushing

This Heatlock series, below, is currently being replaced by the A1-series of nozzles.
Before you design check availability, stock is gradually decreased.
Spare parts will be available until at least end of 2007 (apart form NPT1 bodies)
NPT3
Ø56 f8
Ø25
Ø9
”L”
mm
Single-cav.
Part No.
Multi-cav.*
Total volume
of feed
channel in
mm 3
46 NPT3046411 NPT3046412 4121
66 NPT3066411 NPT3066412 5393
86 NPT3086411 NPT3086412 6665
28
116 NPT3116411 NPT3116412 8572
146 NPT3146411 NPT3146412 10480
176 NPT3176411 NPT3176412 12387
+0.1
-0,02
* with O-ring 630
Can be controlled with various types of temperature controllers intended for
hot runner systems with 220/240 V using thermocouple of type Fe-CuNi.
Recommended for the following maximum shot weights:
Low-viscosity plastic (PS,PE,PP)
Med.-viscosity plastic (ABS,SAN, PA,POM)
High-viscosity plastic (PC,PMMA, Noryl, Filled material)
1000g
500g
300g
15,5
Length expansion at: °C=”L”+X,xx
°C 46 66 86 116 146 176
200 0,11 0,15 0,20 0,27 0,34 0,40
250 0,13 0,19 0,25 0,33 0,42 0,51
300 0,16 0,23 0,30 0,40 0,50 0,61
350 0,19 0,27 0,35 0,47 0,59 0,71
Ø27
To ensure minimum vestige on the part, measure the actual "L" measurement
on each bush, add the length expansion according to the table to get
the hole depth ("L"+X,xx) to be drilled in the cavity plate.
Före inbyggnad, mät upp bussningens nominella "L"-mått, lägg därefter till
längdutvidgningen så att bussningens spets ligger exakt vid intagspunkten i
uppvärmt tillstånd.
28,5
8
Ø9
Ø56 H7
2,5
+0,01
-0
28
L
11,9
1.2
Ø30
15°
R0,4 max
R2
R1
Ø19 H7
Ø0,01
110°
0,2
L
8±0,0025
Ø27,4
14,5
max 1,5
Ø1,8-4
more
2.11.2 Date: 031029, © LKM Heatlock Co Ltd