Gel Doc™ XR ChemiDoc™ XRS
Gel Doc™ XR ChemiDoc™ XRS
Gel Doc™ XR ChemiDoc™ XRS
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Appendix B: ChemiDoc <strong>XR</strong>S System Cable Configuration<br />
a. Connect the motorized zoom lens cable (which is permanently attached to the lens) to the MZL<br />
Extension Cable and then to 5-pin din connector labeled LENS on the connector panel of the<br />
hood.<br />
b. Connect the Camera power cable to the connector on the Camera labeled POWER (See<br />
picture below)<br />
Camera Power Supply Camera Power Cable Power connector on the Camera<br />
c. Connect one end of the Camera Controller cable to the connector on the Camera labeled<br />
DATA and the other end of this cable should be connected to the PCI Digitizing Card after the<br />
card is installed in the PC per procedure in Step 4.2.3.<br />
Camera Controller Cable and Connector<br />
Controller Cable Connector labeled Data<br />
d. Connect the provided Serial Cable to the 9-pin D-SUb/8 pin round serial connector on the<br />
PC/Mac and the other end of the 25 pin serial connector on the Hood.<br />
e. In case of a Mac with a USB, connect the optional (170-7959) USB to Serial adapter (not<br />
included) with a USB cable to the Mac and then connect the 8 pin round connector of the<br />
Mac serial cable (170-7963) between the adapter and the Hood.<br />
f. Now proceed with installation of the PCI Digitizing Card and software.<br />
CONNECTOR PANEL FOR ON THE HOOD<br />
Page 36 of 42