CANgate User's Manual - dataTaker
CANgate User's Manual - dataTaker CANgate User's Manual - dataTaker
DTCs (Fault Codes) OBD-II Diagnostic Trouble Codes (DTCs) are normally written as a letter followed by four decimal digits. The letter describes the category: P (powertrain), B (body), C (chassis) or U (network). For example: P0118 - Engine Coolant Temperature Circuit High Input P0203 - Injector Circuit Malfunction - Cylinder 3 U0003 - High Speed CAN Communication Bus (+) Open When a DTC is returned it is encoded as a 16-bit value, as follows: b15..14 – first character (00=P, 01=C, 10=B, 11=U) b13..12 – second character (0-3) b11..8 – third character (0-9) b7..4 – fourth character (0-9) b3..0 – fifth character (0-9) UM-0086-A2 CANgate User’s Manual Page 42
- Page 1 and 2: ~® Intelligent Data Logging Produc
- Page 3 and 4: Contents Contents .................
- Page 5 and 6: Introduction About CANgate CAN (Con
- Page 7 and 8: CANgate Hardware Connectors and LED
- Page 9 and 10: CAN/GPS/Power Connections The suppl
- Page 11 and 12: To reassemble: 1. Slide the printed
- Page 13 and 14: Memory Slot Commands and Protocol H
- Page 15 and 16: Command Summary { slot } RECV CANpo
- Page 17 and 18: RECV 1 0x603 3.8 3.5 ALL FORMAT .25
- Page 19 and 20: RECVJ - Receive J1939 Messages wher
- Page 21 and 22: Examples GPS "GPGLL" 1 D 5000 Recei
- Page 23 and 24: RP - Poll Memory Slot RP { slot1 sl
- Page 25 and 26: protocol used to break up and reass
- Page 27 and 28: Example STATS HOST: Tx:218408 Rx:12
- Page 29 and 30: Data Range: 0 to 8031.875 rpm Type:
- Page 31 and 32: mode byte and the PID. RQST 1 010C
- Page 33 and 34: The flip-side of this capability is
- Page 35 and 36: Requested CAN data are not returned
- Page 37 and 38: Upgrading CANgate Firmware From tim
- Page 39 and 40: Power Supply External Input Range:
- Page 41: 15-17 2 …as above for Bank 1 sens
DTCs (Fault Codes)<br />
OBD-II Diagnostic Trouble Codes (DTCs) are normally written as a letter followed by four decimal digits. The letter describes<br />
the category: P (powertrain), B (body), C (chassis) or U (network). For example:<br />
P0118 - Engine Coolant Temperature Circuit High Input<br />
P0203 - Injector Circuit Malfunction - Cylinder 3<br />
U0003 - High Speed CAN Communication Bus (+) Open<br />
When a DTC is returned it is encoded as a 16-bit value, as follows:<br />
b15..14 – first character (00=P, 01=C, 10=B, 11=U)<br />
b13..12 – second character (0-3)<br />
b11..8 – third character (0-9)<br />
b7..4 – fourth character (0-9)<br />
b3..0 – fifth character (0-9)<br />
UM-0086-A2 <strong>CANgate</strong> User’s <strong>Manual</strong> Page 42