NSG 9000-6G - Harmonic Inc

Chapter 4 Configuring Applications
SDV Application
1. Select Applications > Broadcast > PSIP.
Select the required
QAM
2. To select the required QAM/TS, open the Module list, Port list and QAM list and select the
required module, port and QAM, respectively.
Once you have indicated the required module, port and QAM, a table appears in the PSIP
page.
3. To add a blank row to the table, click Add Entry.
To delete an entry, click Delete Entry.
4. View/configure the following parameters required for PSIP generation:
# - view the sequential number of the table entry.
Name - enter the name of the program/service to appear in the PSIP table. The
default service name is Ch 1.
Major - indicates a major broadcast group. Enter a number in the range of 0-1023.
Minor - enter a number in the range of 0-1023.
4.4 SDV Application
Service ID - enter the ID of the service routed to the QAM. In case PSIP is enabled for
the QAM and the routed service is not indicated in the PSIP tables, the following
values appear in the table:
Name - CHxxxx, where xxxx indicate the service ID.
Major - assumes the TS ID
Minor - default value is service ID
The SDV application includes the following tabs:
• Settings - allows you to set the following:
SDV redundancy
MPEG related parameters
• QAMs - a read only page to view QAMs settings
• NGOD Active Sessions - lists all the provisioned NGOD sessions.
• ISA Active Sessions - lists all the provisioned ISA sessions.
© 2012 Harmonic Inc. 90 NSG 9000-6G, Version 2.7, Rev B