NSG 9000-6G - Harmonic Inc

Chapter 4 Configuring Applications
Broadcast Application
Y – RF port number (1…2)
Z – channel number (1…8/6-Annex A)
T – QAM index number (1…144)
6. In Output PID enter the output PID number in hexadecimal. You can output the PID with
the same input PID number or to remap the PID.
7. To allow PMT reference, select the PMT Ref box.
The ES Type field is enabled.
8. If you selected the PMT Reference box, enter the ES Type to stream out the PID. This is
the ES type that the PMT table points to. See, Standard ES Types and Descriptors on
page 146.
9. To add a descriptor, click Descriptor...
The Descriptor List page opens.
10. Click Add Descriptor.
11. In Descriptor Type and Descriptor Value, enter the required parameters as defined by the
MPEG standard.
12. To close the dialog and save configuration, click Done.
To route a PID using the Duplicate button
Once you defined a PID and need to route another PID with similar configuration, do the
following:
1. In PID Remux page, check the Select box of the required PID.
2. Click Duplicate.
The selected row is duplicated and appears as the last row in the table.
3. Define the required parameters as explained in To route a PID on page 87.
To route a PID to a few output ports
1. In PID Remux, check the Select box of the required PID.
2. Click Duplicate Range.
© 2012 Harmonic Inc. 88 NSG 9000-6G, Version 2.7, Rev B