NSG 9000-6G - Harmonic Inc
NSG 9000-6G - Harmonic Inc
NSG 9000-6G - Harmonic Inc
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 3 Configuring Platform Parameters<br />
EdgeCluster<br />
Table 3-17: EdgeCluster Firmware Upgrade<br />
Primary Device<br />
Backup Device<br />
1. Verify that both devices are working properly.<br />
6. Upgrade the firmware as instructed on<br />
page 24.<br />
7. Verify that the device is running<br />
properly with the newly installed<br />
firmware<br />
8. In the web client of the primary device,<br />
select Platform > Chassis ><br />
EdgeCluster tab.<br />
9. Click Set to Active.<br />
Note: Services are flowing through the<br />
primary device.<br />
2. Upgrade the firmware as instructed on<br />
page 24.<br />
3. Verify that the device is running properly with<br />
the newly installed firmware and apply the<br />
required configuration to the device.<br />
Note: The backup device is currently working with<br />
the new firmware.<br />
4. In the web client of the backup device only,<br />
select Platform > Chassis > EdgeCluster tab.<br />
5. Click Set to Active.<br />
Services are flowing through the backup<br />
device.<br />
3.17.3.2 Replacing a Faulty Module in EdgeCluster Mode<br />
The following instructions refer to devices that work in edgeCluster mode and you need to<br />
replace a faulty QAM-RF module or power supply.<br />
1. Verify that the device with the faulty module is in Standby state.<br />
2. Replace faulty module. See <strong>NSG</strong><strong>9000</strong>-<strong>6G</strong> Hardware and Installation Guide.<br />
3. Verify that the device is working properly.<br />
4. Apply EdgeCluster mode.<br />
© 2012 <strong>Harmonic</strong> <strong>Inc</strong>. 73 <strong>NSG</strong> <strong>9000</strong>-<strong>6G</strong>, Version 2.7, Rev B
Change language