NSG 9000-6G - Harmonic Inc

Chapter 3 Configuring Platform Parameters
EdgeCluster
Configuring and monitoring the EdgeCluster feature is done via the Platform > Chassis >
EdgeCluster tab.
Click to set
to active
Click to set
to standby
View peer
device
state
View
device
state
Set device role,
Primary/backup
Enter/view
device Active/
peer Eth1/2 IP
addresses
Select the
required
application:
Broadcast or
M-CMTS
Select Disabled,
Automatic or
Manual
The EdgeCluster tab includes the following options:
Redundancy Mode - Allows to select the required redundancy mode:
• Disabled - The device operates in a standalone mode
• Automatic - A redundancy switch automatically takes place upon a triggering event. See
3.17.1.1 Triggering Event for Redundancy Switch on page 69.
• Manual - A redundancy switch is initiated by the user
Application - allows to select the required edgeCluster deployment:
• Broadcast
• M-CMTS
ETH1 Peer IP - Allows to configure the IP address of Eth1 of the peer device.
ETH2 Peer IP - Allows to configure the IP address of Eth2 of the peer device.
Device Role - Allows to configure whether primary or backup.
Device State - Read only. View the current state of the device, whether active or standby.
Peer State - Read only. View the current state of the peer device, whether active of standby.
Set to Active - Enabled when device is part of an edgeCluster and the state of the device is
standby or failed.
Set to Standby - enabled when device is part of an edgeCluster configuration and the device
is currently active
© 2012 Harmonic Inc. 70 NSG 9000-6G, Version 2.7, Rev B