NSG 9000-6G - Harmonic Inc
NSG 9000-6G - Harmonic Inc
NSG 9000-6G - Harmonic Inc
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 3 Configuring Platform Parameters<br />
Configuring ISA<br />
<br />
<br />
indication required by the ISA and the RCAS protocols. This message is sent to the<br />
SRM due to the following:<br />
Provisioning a service<br />
Alarm is raised on the session<br />
A redundancy switch over the session source<br />
Session is missing from the output<br />
Report PMT Section (QuerySessionInfo) - when selected, in QuerySessionInfo, the<br />
PMT packet data is sent to the ISA server.<br />
Out Of Band Mini Carousel - applies to ISA-SDV. Select, in case, the mini carousel is<br />
transmitted to the set-top-box out-of-band and not through the video network. When<br />
you enable this parameter, the device does not raise the alarm Service Missing for<br />
mini carousel sessions.<br />
NOTE: The following parameter applies to SDV sessions that are either shell/bind sessions or create<br />
sessions with port 0 or a port higher than 8 only.<br />
<br />
SDV Load-Sharing Ports- applies to ISA-SDV sessions. The input port in the<br />
provisioning message is not indicated. The edgeQAM attempts to receive the input<br />
stream via the input ports indicated in the SDV Load-Sharing Ports box. The default port<br />
is GbE port 1. You can configure up to four GbE input ports to handle up to four<br />
Gigabytes of SDV traffic. The <strong>NSG</strong> manages the traffic between the selected input<br />
ports. The <strong>NSG</strong> sends the sessions to the input port for SDV session with less traffic.<br />
If SDV ports are equally loaded with traffic, the device sends the traffic to the ports<br />
according to the sequential order of the port numbers.<br />
NOTE: GbE input port that is selected as an SDV-load sharing port, cannot be a backup port.<br />
NOTE: To view the actual input port, select Applications > SDV > ISA Active Sessions.<br />
3.16.2 Defining Virtual ISA Units<br />
To enable the ISA server to handle the full capacity of QAM-RFs of the edgQAM, use the<br />
virtual IPs for ISA feature. This feature creates virtual IPs only for the use of the ISA server. To<br />
create virtual ISA IPs, do the following:<br />
• Create virtual IPs for ISA - requires to define:<br />
Eth1 Virtual IPs - You can add virtual IPs to ETh1 only. You can add up to 10 Eth1<br />
virtual IPs. Eth1 virtual IPs should be on a subnet other than Eth2 subnet.<br />
GbE Virtual IPs - You can add GbE virtual IPs to any of the active GbE ports. You can<br />
add up to 10 GbE virtual IPs. The physical GbE port is automatically added as one of<br />
the available virtual port IPs and you cannot remove it.<br />
• Associate virtual devices with ISA<br />
3.16.2.1 Creating Virtual IPs for ISA<br />
<br />
To create Eth1 virtual IP<br />
1. Open the web client of the device.<br />
2. Select the Platform tab.<br />
3. In Back Panel View, select Eth1.<br />
© 2012 <strong>Harmonic</strong> <strong>Inc</strong>. 64 <strong>NSG</strong> <strong>9000</strong>-<strong>6G</strong>, Version 2.7, Rev B