NSG 9000-6G - Harmonic Inc

Chapter 3 Configuring Platform Parameters
Configuring QAM-RF Modules
• Configuring global parameters - the same definitions are sent to all of the QAM-RF
modules/QAM channels. The Global configuration is available via the Platform > General >
Chassis > Global RF & QAMs tab.
• Configuring parameters for each QAM-RF module - To allow the NSG 9000-6G device to
support multiple applications, during this configuration you may override the
configuration of global parameters such as module encoding mode and QAM manager.
The configuration of each QAM-RF module is available via the Platform > General > Slot
Module > Module/Ports/QAMs tabs.
3.12.1 Configuring Global RF & QAMs Parameters
TIP: Defining the global parameters of the RF ports & QAM channels is the first stage of the QAM-RF
module configuration.
When configuring the QAM-RF module parameters, you may send definition to all of the
QAM-RF modules/QAM channels as the following table shows:.
Table 3-6: Setting Global RF&QAM Parameters
Required Action
Required Buttons
To send definitions to all of the QAM-RF
modules, click Set All Modules and then Apply.
To send definitions to all of the RF ports, click
Set All Ports and then Apply.
To send definitions to all of the QAMs, click Set
All QAMs and then Apply.
1.
2.
1.
2.
1.
2.
You can globally configure the following:
3.12.1.1 Defining Global RF and QAMs Settings on page 43
3.12.1.2 Defining Number of QAMs and Enabling RF Ports on page 45
3.12.1.3 Closing/Opening all RF Ports on page 45
3.12.1.4 Configuring a Global QAM Manager on page 46
3.12.1.5 Locking Symbol Rate on page 46
3.12.1.1 Defining Global RF and QAMs Settings
To define RF Scheme and Template
1. Select Platform > General tab.
2. In Back Panel View, select Chassis.
3. Select the Global RF& QAMs tab.
© 2012 Harmonic Inc. 43 NSG 9000-6G, Version 2.7, Rev B