NSG 9000-6G - Harmonic Inc

Chapter 3 Configuring Platform Parameters
Firmware Upgrade
To import configuration
1. Select the Platform tab.
By default chassis is selected.
2. Click Import Configuration to Device.
The Import File To Device dialog appears.
3. To locate the required XML file previously exported, click Browse.
4. To import, click Import.
Wait until a message notifying you of a successful import appears.
5. For the device to run with the newly imported configuration, reset the device.
3.1.1.3 Clearing Configuration
To clear configuration and Revert to Factory Defaults
1. Select the Platform tab.
By default chassis is selected.
2. Click Factory Default.
The following message appears:
This action will clear configuration and reset the device. Are you
sure?
3. To confirm the action, click OK.
The device configuration is removed and device boots up with factory defaults.
3.1.1.4 Resetting an NSG9000 Device
To reset the device
1. Select the Platform tab.
By default chassis is selected.
2. Click Reset Unit.
3. Click Ok to confirm the action.
The reset process takes place.
3.1.1.5 Resetting a QAM-RF Module
To reset a QAM-RF module
1. Select the Platform tab.
2. Select the required slot/QAM-RF module.
3. Click Reset Module.
4. Click Ok to confirm the action.
The reset process takes place.
3.2 Firmware Upgrade
NSG 9000-6G ships with firmware and the web client installed. However, Harmonic
periodically releases firmware updates. To find out if the provided firmware meets your needs
or must be updated, contact Harmonic Technical Support.
© 2012 Harmonic Inc. 23 NSG 9000-6G, Version 2.7, Rev B