NSG 9000-6G - Harmonic Inc

Appendix D
Control Panel
D.1 Using the Control Panel
You can set preliminary configuration and control the NSG 9000-6G unit via its front panel.
The front panel includes a control panel comprised of a Liquid Crystal Display (LCD) and six
buttons as the following figure shows:
LCD Display Right key Up key Ok key
Esc key
Down key
Left key
D.1.1 Control Panel Display
The 2-line, 16-character control panel display shows the screens, sub-screens, sub-screen
options, error messages, warnings and alarms. The control panel display is comprised of two
lines:
Line 1 - displays the name of the current screen/sub-screen or selected option.
Line 2 - displays the parameter value and all editing tasks are performed in this line. In editing
mode the cursor is blinking to indicate the selected character.
D.1.2 Control Panel Screen Concept
The control panel screens are organized in a hierarchical fashion to indicate that a main
screen contains sub-screens and sub-screen options. You may access a sub-screen only via
its main screen. The available main screens are as follows:
Power Up screen - A main screen that appears as soon as the NSG 9000-6G boots up and
after a thirty minutes of inactivity. The screen shows the company’s name, NSG 9000-6G type
and IP address.
Network Config screen - allows to access sub-screens for ETH configuration.
Setup screen - allows to reset the device.
Alarm screen - displays the last active alarm or warning. You can browse through the alarms
to view them.
Product Information screen - via its sub-screens you can view information about the NSG
9000-6G.
© 2012 Harmonic Inc. 148 NSG 9000-6G, Version 2.7, Rev B