INSTALLATION MANUAL

More documents

Recommendations

Info

2. SURFACE Install anchor bolts or earth anchors, depending on your building, 18" offset from the center of the common arch to attach the cover end flap ratchets. 3. COVER <strong>INSTALLATION</strong> 1. Install the first cover and secure in the normal fashion except that the end flap on the common arch is not secured at this time. Flip the end flap back and out of the way. 2. Install, the next cover and secure in the normal fashion, lacing the PVC tube to the common arch. Do not tighten the lashing winches at this time. 3. Release the fastening strap in the end arch winch of the first building. Join the fastening pipes of both covers and secure with self-drilling screws. Place the fastening strap over the pipe and re-install the end fastening strap in the winch. Tighten the lashing winches of the next cover. NOTE: Both covers share a common end fastening strap and lashing winch. 4. Place the end flap of the first cover over the next cover's lacing (see note). Attach the belting for this first (inner) end flap to the ratchets. Tighten the ratchets. 5. Place the end flap (outer) of the next cover over the first (inner) end flap. Cut a slit in the first (inner) end flap at the point where the fastening strap for the inner end flap exits its pocket. Feed the fastening strap through the slit and attach to the ratchets. Tighten the ratchets. 6. Apply a bead of silicone (supplied) between the outer end flap and the cover. Insert the tube tip between the layers with all straps fastened securely. Walk on the building to seal the top portion of the end flap and use a ladder or lift equipment to reach the sides. Where it is difficult to reach some areas, unsealed portions should not exceed 3 feet. NOTE: If your building is subject to prevailing winds, you should secure the flaps to 23 protect the overlap. Q205.1.1
IMPORTANT: Extended buildings require braced bays at specific locations. Follow the Special Instructions that come with your building. Install special purlins as required. APPENDIX B FINISHING THE SIDE WALLS THE FOLLOWING DESCRIBE A 4 FOOT (48") SIDE WALL CLADDING A - NON-VENTILATION - for Commercial and Storage purposes: 1. Requires 2" x 4" dimensional lumber to use as strapping. 2. Sheets of plywood, OSB Board (chipboard), or alternate material suitable for lining the inside walls. 24 Q205.1.1
Page 1 and 2: # Q205.1.1 Manual SUPERCEDES - Q205
Page 3 and 4: IMPORTANT - READ MANUAL FIRST Impro
Page 5 and 6: Step 2 REQUIRED EQUIPMENT AND MATER
Page 7 and 8: Step 4 BUILDING LAYOUT SERIES 20 (W
Page 9 and 10: Step 6 POST INSTALLATION MAX MAX 8
Page 11 and 12: 26 / 30 BUILDINGS GO TO STEP 10, PA
Page 13 and 14: Step 9 20 / 22 CONTINUED NO HOLE 12
Page 15 and 16: Step 10 26 / 30 CONTINUED NO HOLE 1
Page 17 and 18: Step 10 26 / 30 CONTINUED ON THE UN
Page 19 and 20: Step 14 INSTALL THE COVER FASTENING
Page 21 and 22: Step 16 INSTALL THE PVC PIPE 1. Onc
Page 23: Step 20 SECURE THE APRON The fabric
Page 27 and 28: CONVERSIONS INCHES MILLIMETERS 1/32
Page 29 and 30: ANCHOR REFERENCE - cont. All anchor
Page 31 and 32: LIMITED WARRANTY QUICKSTRUCTURES QS

INSTALLATION MANUAL

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?