INSTALLATION MANUAL
INSTALLATION MANUAL
INSTALLATION MANUAL
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SECURE THE END FLAP<br />
Step 18<br />
REMOVE ALL ROPES BEFORE PROCEEDING<br />
If rope is trapped between the cover and the arches remove SLOWLY.<br />
1. POSTS MOUNT BUILDINGS<br />
Install the 4 end flap ratchets, one on<br />
each corner post, by drilling 3/8" holes<br />
24" below the top of the posts and<br />
installing 3/8" threaded rod, washers and<br />
nuts and an end flap ratchet. Add tension<br />
to the end flaps until they are tight.<br />
2. SURFACE MOUNT BUILDINGS<br />
Depending on the building type and<br />
surface, install anchor bolts or earth<br />
anchors beside the end arch bases and attach a ratchet strap.<br />
NOTE: It may be necessary to repeat<br />
the ratchet tightening several<br />
times at both ends of the<br />
cover. You may need to<br />
release the ratchet<br />
mechanism and pull the<br />
belting as tight as possible by<br />
hand before ratcheting.<br />
Step 19<br />
TENSION THE COVER<br />
1. Use a 1 1/8" wrench to tighten the cover lashing straps<br />
evenly on both sides of the building. Adjust the cover lashing<br />
winches to achieve a wrinkle free, drum tight appearance<br />
over the entire building. For most buildings 25 - 35 ft. lbs of<br />
torque provides adequate cover tension.<br />
2. Next, adjust the end lashing straps tension<br />
until the cover fastening pipes are level.<br />
3. Install a cotter pin in the lashing winch pilot<br />
holes to lock the release lever.<br />
4. Secure the outside (end) lashing straps (4) to<br />
the fastening pipe by using pipe clips or fender washers and 1/4 x 3/4"<br />
Tek 3 self-drilling screws. Install the screws through the fastening<br />
strap into the fastening pipe.<br />
NOTE: Failure to secure the corner fastening straps to the pipe could<br />
result in possible damage to the cover.<br />
21<br />
Q205.1.1