INSTALLATION MANUAL

More documents

Recommendations

Info

Step 10 26 / 30 CONTINUED NO HOLE NOTE: Some downward pressure may be required to have arches meet in the middle. 15 Q205.1.1
Step 10 26 / 30 CONTINUED ON THE UNDERSIDE OF THE FRAME Tie the frame together with 2 ropes. Leave ropes until the cover is completely installed. Tighten all base plate bolts. NOTE: Inspect all frame connections for burrs or rough edges which may have developed during handling or assembly and file them smooth. Step 11 INSTALL COVER LASHING WINCHES POST 1. To install winches measure approximately 24” from the top of the post and drill an 11/16" hole. Mount the winch using 5/8” threaded rod, washers and nuts. Drill through the interior wall if necessary. 2. Mount one cover lashing winch on the outside of each of the 4 corner posts. 3. 4' post spacing mount a winch on every 3rd post – every 12'. 5' post spacing mount a winch on every other post – every 10'. 6' post spacing mount a winch on every other post – every 12'. In some cases the last winches installed will be mounted on posts next to the end posts at one end of the building. SURFACE 16 Winches must be installed on base before frame erection - see STEP 5 on Page 7. Q205.1.1
Page 1 and 2: # Q205.1.1 Manual SUPERCEDES - Q205
Page 3 and 4: IMPORTANT - READ MANUAL FIRST Impro
Page 5 and 6: Step 2 REQUIRED EQUIPMENT AND MATER
Page 7 and 8: Step 4 BUILDING LAYOUT SERIES 20 (W
Page 9 and 10: Step 6 POST INSTALLATION MAX MAX 8
Page 11 and 12: 26 / 30 BUILDINGS GO TO STEP 10, PA
Page 13 and 14: Step 9 20 / 22 CONTINUED NO HOLE 12
Page 15: Step 10 26 / 30 CONTINUED NO HOLE 1
Page 19 and 20: Step 14 INSTALL THE COVER FASTENING
Page 21 and 22: Step 16 INSTALL THE PVC PIPE 1. Onc
Page 23 and 24: Step 20 SECURE THE APRON The fabric
Page 25 and 26: IMPORTANT: Extended buildings requi
Page 27 and 28: CONVERSIONS INCHES MILLIMETERS 1/32
Page 29 and 30: ANCHOR REFERENCE - cont. All anchor
Page 31 and 32: LIMITED WARRANTY QUICKSTRUCTURES QS

INSTALLATION MANUAL

Create successful ePaper yourself

Delete template?

Save as template?