2003 LSSV Operator Manual Supplement (PDF) - GM Fleet

More documents

Recommendations

Info

Pintle Hitch A pintle hitch is located at the rear of the vehicle, and is removable from the receiver. Notice: Before operating, inspect for proper operation, worn, damaged or missing parts and secure mountings. Correct as required before use. Operating the Pintle Hitch: To Open: 1. Open the latch by removing latch pin (F). 2. Pull up on the lock latch (C) while lifting the latch (D). To Close: 1. Push the latch (D) until the lock latch (C) locks in place. 2. Install the latch pin (F). Installing the Pintle Hitch: 1. Remove any debris from the inside of the receiver. 2. Push the pintle hitch (E) into the receiver. 3. Install the retaining pin (B) into the receiver and the pintle hitch (E). 4. Install the spring clip (A) into the retaining pin (B). 15367 4-10
Trailer Wiring Connector Trailer Connector Adapter 10250 On the military bumper the NATO standard 12-pin trailer lamp and brake connector is located on the rear bumper between the right clevis/tie-down and the pintle hitch. On the factory bumper the NATO standard 12-pin trailer lamp and brake connector is located on the rear trailer hitch to the left of the pintle hitch. When connecting a trailer wiring harness to the connector, make sure the dog ears of the connector are properly aligned when inserting it into the connector. 7112 When connecting to a commercial trailer with an 8-pin connector, the adapter must be used. This adapter allows you to connect an 8-pin trailer wiring harness into the vehicle’s 12-pin connector. 4-11
Page 1 and 2: 2003 General Motors Light Service S
Page 3 and 4: Index A good place to look for what
Page 5 and 6: Section 1 Seats and Restraints Troo
Page 7 and 8: Restraints Rear Safety Strap 9557 2
Page 9 and 10: Section 2 Features and Controls Win
Page 11 and 12: Sliding Rear Window If the vehicle
Page 13 and 14: Storage Areas Cargo Cover-Soft Top
Page 15 and 16: Cargo Tie Downs If the vehicle is e
Page 17 and 18: Upper Weapon Mount 2. Place the bar
Page 19 and 20: Section 3 Instrument Panel Exterior
Page 21 and 22: emain functional. • The hazard li
Page 23: Exterior Lamp or Device Instrument
Page 26 and 27: Warning Lights, Gages and Indicator
Page 28 and 29: NOTES 3-10
Page 30 and 31: Your Driving, the Road and the Vehi
Page 32 and 33: Permanent Mount Control of the Winc
Page 34 and 35: Front Clevis/Towing Provisions 1472
Page 36 and 37: Towing Towing The Vehicle When towi
Page 42 and 43: Underhood Component Locator 13905 T
Page 45 and 46: CAUTION: Using a open flame near a
Page 47 and 48: 9. Start the vehicle with the good
Page 49 and 50: 2. Turn off the ignition on both ve
Page 51 and 52: Replacement Bulbs Lamp Blackout Hea
Page 53 and 54: Vehicle Information Shipping Data P
Page 57 and 58: Section 6 Maintenance Schedule Main
Page 59 and 60: Fuel Fired Coolant Heater Inspectio
Page 61 and 62: Section 7 Customer Assistance Infor
Page 63 and 64: A Appearance Care..................
Page 65 and 66: R Rear Axle Vent-Tube Filter.......

2003 LSSV Operator Manual Supplement (PDF) - GM Fleet

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?