C-Series Book - Industrial Engine Service
C-Series Book - Industrial Engine Service C-Series Book - Industrial Engine Service
7 Notes 34 C-SERIES SERVICE, OPERATION & PARTS MANUAL – AEPB1 1-800-331-3662
8 TROUBLESHOOTING 8 ENGINE WON’T START No Ignition Spark 1. Low oil pressure switch tripped – reset switch. 2. Low oil level – refi ll crankcase with proper motor oil to full level. 3. Low water level switch in shutoff position – refi ll cooling system with coolant to proper level. 4. Damaged ignition wire or terminals – replace. 5. Faulty Ignition 6. Faulty spark plug – remove and replace. No Fuel 1. Be sure the fuel gas is turned on at the main valve and that there is gasoline in the fl oat bowl, if furnished. 2. Be sure the fuel hose is not kinked or stopped up, and is of suffi cient size as to not restrict the flow of fuel gas. No Compression 1. Be sure compression release is in down position. 2. Stuck valve-remove valve cover and check valves to see that both are opening and closing while turning engine over. Often a stuck valve may be freed up by spraying with light oil and tapping with a small hammer. If this doesn’t work, the head will have to be removed. 3. Valve adjustment backed off - readjust valves to .020 clearance. 4. Valve burned - remove head and recondition. Engine Flooded 1. Remove spark plug – turn engine over several times with compression release in down position to blow surplus fuel out cylinder – clean plug and reinstall. 2. Try cranking engine with fuel shut off to clear cylinder of remaining fuel. 3. Start engine in usual manner. 1-800-331-3662 ARROW ENGINE COMPANY 35
- Page 1: AEPB1 © November 2010
- Page 4 and 5: 4 IGNITION SYSTEM 17 Magneto-Low Te
- Page 6 and 7: iv C-SERIES SERVICE, OPERATION & PA
- Page 8 and 9: the cooling system. The proper wate
- Page 10 and 11: 1 3. Raise compression release leve
- Page 12 and 13: 1 OIL PUMP A trochoidal or gerotor
- Page 14 and 15: 1 Notes 8 C-SERIES SERVICE, OPERATI
- Page 16 and 17: 2 FUEL CONNECTION An extended line
- Page 18 and 19: 2 If we use the same example, burni
- Page 20 and 21: 3 When the pressure-condensing cool
- Page 22 and 23: 3 Notes 16 C-SERIES SERVICE, OPERAT
- Page 24 and 25: 4 For protection against enforced s
- Page 26 and 27: 5 The constant fl ow of fresh air i
- Page 28 and 29: 6 Slide the splined lever onto the
- Page 30 and 31: 6 3. Adjustment Proper adjustment o
- Page 32 and 33: 6 If proper adjustment cannot be re
- Page 34 and 35: 6 Notes 28 C-SERIES SERVICE, OPERAT
- Page 36 and 37: 7 REASSEMBLY OF CYLINDER HEAD 1. To
- Page 38 and 39: 7 FITTING PISTON RINGS 1. Place the
- Page 42 and 43: 8 CLUTCH WON’T PULL OR HEATS Clut
- Page 44 and 45: 8 ENGINE FAILS TO OPERATE PROPERLY
- Page 46 and 47: 9 C-101 Emission Set Points RPM RAN
- Page 48 and 49: 9 42 C-SERIES SERVICE, OPERATION &
- Page 50 and 51: 10 CLEARANCES AND TOLERANCES - CRAN
- Page 52 and 53: 10 CLEARANCES AND TOLERANCES - CAMS
- Page 54 and 55: 10 CLEARANCES AND TOLERANCES - CONN
- Page 56 and 57: 10 DIMENSIONS (To remove head and p
- Page 58 and 59: 10 HORSEPOWER DERATES Condition Con
- Page 60 and 61: 11 11 PARTS CRANKCASE ASSEMBLY 29 3
- Page 62 and 63: 11 CRANKSHAFT ASSEMBLY 1 10 2 8 7 5
- Page 64 and 65: 11 CYLINDER HEAD ASSEMBLY 11 4 13 1
- Page 66 and 67: 11 GOVERNOR ASSEMBLY 176-46/66/96 G
- Page 68 and 69: 11 176-RK-46 Governor Repair Kit, C
- Page 70 and 71: 11 ROCKER ARM ASSEMBLY 9 14 13 15 1
- Page 72 and 73: 11 PRESSURE CONDENSING GROUP 11 8 2
- Page 74 and 75: 11 356-A-RK-46 Fan Repair Kit Descr
- Page 76 and 77: 11 CLUTCH ASSY 1 7" Double Bearing
- Page 78 and 79: 11 CLUTCH ASSEMBLY 1 10" 2 6 3 4 5
- Page 80 and 81: 11 CLUTCH ASSEMBLY 11" 1 5 2 3 4 6
- Page 82 and 83: 11 RING GEAR, STARTER & INSTRUMENT
- Page 84 and 85: 11 ARROW PORTABLE ELECTRIC STARTER
- Page 86 and 87: 11 MAGNETO - AMERICAN BOSCH ASSY (H
- Page 88 and 89: 11 MAGNETO ACCESSORIES 11 14 15 18
7<br />
Notes<br />
34 C-SERIES SERVICE, OPERATION & PARTS MANUAL – AEPB1 1-800-331-3662