LSR130 Bar Code Imager User Guide - Access IS

LSR130 Bar Code Imager
User Guide
Introduction
The LSR130 is a compact 2D bar code reader with integrated manual MSR and
optional OCR. The LSR130 provides a robust and cost-effective solution for check-in
areas, duty-free shops and airport lounges that typically handle 2D airline and home
printed documents but have the occasional need to read ATB2 documents, credit cards
and frequent flyer cards (FQTV). The optional OCR reads machine readable passports,
visas, travel documents conforming to ICAO recommendation 9303, TAT and ATB
tickets, resident alien and Green Cards..
For the latest information, go to www.access-is.com
Wide document
throat facilitates
reading of bar code
at any position
on an A4 document
or on a mobile phone
Highly visible green/red
LEDs and audible alarm
provide positive read
confirmation to the agent
Ergonomic
document
reading channel

Installation
The LSR130 connects to the host workstation by means of a RJ-50 connector on
the rear of the unit. Power is supplied through use of the included power supply
into this cable. The second RJ-50 socket is for use with the optional receipt
printer (see printer instructions).
The LSR130 is supplied with the following accessories:
5KBD172102 Serial Cable
PSU5V2A Universal AC Power Supply
RJ-50 connection
to host workstation
Configuration
Auxiliary RJ-50 port Connection for
optional receipt
printer
Rear
view
On/off switch
The LSR130 serial port configuration, including the host protocol, may be achieved in
either of the following ways:
1. Using the Access IS “ZippyTools” utility;
2. Using a configuration barcode provided by Access IS.
The LSR130 will have been shipped pre-configured to customer specifications. In case
of difficulty, please contact Access IS sales department on +44 (0) 118 966 3333 or
email sales@access-is.com

Bar Code Reading
To read a bar coded check in ticket, place the document face-up into the bar
code reader zone. Once the document is detected, the bar code reader’s LEDs
will illuminate the document (the bar code on a mobile phone or PDA will be
automatically illuminated at a lower level than a bar code on a paper document to
optimise bar code reading).
The bar code imager is omni-directional, and a well-printed document should be
read almost immediately and in any orientation. Improved read performance will
be achieved if the document is held flat on the surface under the bar code reader.
The LSR130 will determine if the document is valid and the green LED will be
illuminated.

MSR / ATB2 Reading
OCR / Passport Reading
To read an ATB or a document or
mag stripe card, swipe the media
with the magnetic stripe facing
into the unit, that is away from the
operator.
The swipe reader is omni-directional
so the mag stripe can be swiped in
either direction.
To read an OCR document, swipe
the OCR with the characters/printed
side facing away from the unit, that is
towards the operator.
The swipe reader is omni-directional
so the OCR can be swiped in either
direction.
Access IS
18 Suttons Business Park
Reading, Berkshire
RG6 1AZ, United Kingdom
Tel: +44 (0) 118 966 3333
Fax: +44 (0) 118 926 7281