cross section crash boxes

More documents

Recommendations

Info

(a) (b) (c) (d) Figure 3.9. a) Experimental and b) numerical deformation behavior of circular tubes with 6 grooves and comparison of load-deformation graphs of circular tubes with c) non-grooved, 3,4 and 6 grooves, d) 12 and 18 grooves (Source Mamalis, et al. 2003b). 40
(a) (c) Figure 3.10. Deformation mode of a) concertina and diamond b) with 3 circumferential waves and c) 4 circumferential waves, (Source: Marsolek and Reminerdes 2004). (b) 41
Page 1 and 2:
OPTIMIZATION OF THE AXIAL CRUSHING
Page 3 and 4:
ACKNOWLEDGEMENTS My PhD quest has b
Page 5 and 6:
ÖZET KAPALI HÜCRELİ ALUMİNYUM K
Page 7 and 8:
CHAPTER 4 EXPERIMENTAL DETAILS ....
Page 9 and 10: CHAPTER 8 ALUMINUM CRASH BOX OPTIMI
Page 12 and 13: Figure 3.7. Simulations of the defo
Page 14 and 15: Figure 4.9. Dimensions of tensile t
Page 16 and 17: Figure 6.21. Sequential deformation
Page 18 and 19: Figure 7.20. Sequential deformation
Page 20 and 21: LIST OF TABLES Table Page Table 4.1
Page 22 and 23: Figure 1. 1. The body in white stru
Page 24 and 25: Figure 1. 4. Commercial crash boxes
Page 26 and 27: CHAPTER 2 AL CLOSED CELL FOAMS: PRO
Page 28 and 29: The processing methods and mechanic
Page 30 and 31: Figure 2. 5 The preferred particle
Page 32 and 33: Figure 2. 8. Typical cellular struc
Page 34 and 35: Figure 2. 10. Manufacturing cost of
Page 36: Figure 2. 12. Laser assisted foamed
Page 41 and 42: Figure 2.16. Shear strength, normal
Page 43 and 44: Figure 2. 19. Yield strength vs. re
Page 45 and 46: Figure 2. 21. Unit cell geometry an
Page 47 and 48: Figure 2. 24. Load-displacement cur
Page 49 and 50: Figure 2. 26. The photographs of a
Page 51 and 52: CHAPTER 3 CRUSHING BEHAVIOR OF TUBU
Page 53 and 54: Figure 3.2. Diamond deformation mod
Page 57 and 58: deformation mode transition from ax
Page 59: Figure 3.8. Energy absorption of qu
Page 65 and 66: (a) (b) Figure 3.13. a) Schematic o
Page 67 and 68: (a) (b) (c) Figure 3.15. a) Load-di
Page 72 and 73: Figure 3.18. The crush terminology.
Page 75 and 76: The quasi-static compression behavi
Page 77 and 78: Figure 3.22. The variation of speci
Page 79 and 80: Figure 3.24. Deformation modes of e
Page 81 and 82: Figure 3.27. SEA values of empty an
Page 83 and 84: Figure 3.29. (cont.) 3.5. Motivatio
Page 85 and 86: CHAPTER 4 EXPERIMENTAL DETAILS 4.1.
Page 87 and 88: (a) (b) Figure 4.3.Pictures of a) f
Page 89 and 90: oxes are shown in Figure 4.6. The l
Page 91 and 92: Figure 4.7. The method of trigger m
Page 93 and 94: 4.4. Compression Tests of Crash Box
Page 95 and 96: 4.5.2. Uniaxial Compression Testing
Page 97 and 98: Table 4.1 (Cont.) G1 T3 F2 G1T3F2 3
Page 99 and 100: Table 4.2 (Cont.) G1 T2.5 WP F2 G1T
Page 101: CHAPTER 5 SIMULATION AND OPTIMIZATI
Page 105: considered in axial and transverse
Page 109 and 110: were constrained. Since the width o
Page 116 and 117:
5.4. The Crashworthiness Optimizati
Page 118 and 119:
great effect on the crushing behavi
Page 120:
CHAPTER 6 EXPERIMENTAL RESULTS 6.1.
Page 124 and 125:
Figure 6.3.Tensile stress-strain cu
Page 126 and 127:
(a) (b) Figure 6.5. Sequential defo
Page 128 and 129:
plate (Figure 6(b)). The trigger is
Page 130 and 131:
(a) (b) Figure 6.9. Deformation seq
Page 132 and 133:
Figure 6.12. Sequential deformation
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Figure 6.18. (cont.) (c) (a) (b) Fi
Page 140 and 141:
Figure 6.20.(cont.). (b) (c) 6.5.4.
Page 142 and 143:
Figure 6.21.(cont.) (b) (c) 122
Page 144 and 145:
Figure 6.22.(cont.) (c) Figure 6.23
Page 146 and 147:
Figure 6.24.(Cont.) (b) (c) (a) Fig
Page 148 and 149:
Figure 6.26.(cont.) (b) (c) 6.6. Dy
Page 150 and 151:
Figure 6.27. (cont.) (b) (c) 130
Page 152 and 153:
CHAPTER 7 MODELING RESULTS OF FOAM,
Page 154 and 155:
experimental tensile stress-strain
Page 156 and 157:
significant effect of weld seem ope
Page 158 and 159:
Figure 7.7. Deformation photo of fi
Page 160 and 161:
Figure 7.11. Deformation photos of
Page 162 and 163:
(a) (b) (c) Figure 7.14. Load-displ
Page 164 and 165:
7.4. Simulation of Empty and Partia
Page 166 and 167:
Figure 7.16. (cont.) (c) (a) Figure
Page 168 and 169:
(a) (b) Figure 7.18. Sequential def
Page 170 and 171:
Figure 7.19. (cont.) (b) (c) 150
Page 172 and 173:
Figure 7.20. (cont.) (c) (a) Figure
Page 174 and 175:
Page 176 and 177:
Page 178:
(a) (b) Figure 7.26. Experimental a
Page 182 and 183:
The constructed response surface of
Page 184:
Table 8.1. R 2 , Radj 2 and RMSE va
Page 187 and 188:
(a) (b) Figure 8.7. Response surfac
Page 189 and 190:
an empty tube wall thickness higher
Page 192 and 193:
where, K is a dimensionless constan
Page 194 and 195:
The dynamic simulation and analytic
Page 196:
Figure 9.4. (cont.) (c) (d) Figure
Page 199 and 200:
Figure 9.6. (cont.) (c) (d) (a) Fig
Page 203 and 204:
Equation 9.7 can also be rewritten
Page 206:
(a) (b) Figure 9.10. Energy-absorbi
Page 209 and 210:
Figure 9.11. (cont.) (d) The variat
Page 211 and 212:
foam filling were evaluated. The re
Page 213 and 214:
13. The interaction between foam fi
Page 215 and 216:
Arora, J. S.,2004,Introduction to O
Page 217 and 218:
Dannemann, K. A. and Lankford, J.,
Page 219 and 220:
Hall, I. W., Guden, M. and Yu, C. J
Page 221 and 222:
Kim, D-K. and Lee, S., 1999, Impact
Page 223 and 224:
Mamalis, A. G., Manolakos, D. E., I
Page 225 and 226:
Pugsley, A. G. and Macaulay, M., 19
Page 227 and 228:
T. Miyoshi, M. Itoh S. Akiyama A. K
Page 229:
Zhao, H., Elnasri, I. and Girard, Y
show all

cross section crash boxes

Create successful ePaper yourself

Delete template?

Save as template?