InterLab System User Manual
InterLab System User Manual
InterLab System User Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1.8.5. Configuration<br />
<strong>InterLab</strong> <strong>System</strong> - <strong>User</strong> <strong>Manual</strong><br />
After installation you should configure all programs. ilsImageProcessor should be configured at<br />
first to enable work for other <strong>InterLab</strong> <strong>System</strong> programs (refer to paragraph 3.2.).<br />
After ilsImageProcessor configuration you may set all required parameters in ilsPrintMaker and<br />
ilsCDMaker software.<br />
To carry out configuration in ilsPrintMaker and ilsCDMaker, run them in sequence and click on<br />
the button located in the right top corner. This button appears below:<br />
Enter to<br />
CONFIGURATION PANEL<br />
After that in each program you get configuration screen. There is a description for each parameter<br />
on the screen describing the parameter.<br />
All configuration steps for each programs are described in relevant chapter for the application<br />
(refer to paragraph 2.10 [ilsPrintMaker] and paragraph 5.3.4. [ilsCDMaker]).<br />
After configuring all software – system is ready for production.<br />
1.8.6. Backup of data and settings<br />
In <strong>InterLab</strong> <strong>System</strong> software backup is straightforward.<br />
To carry out backup enter to directory and make copy of <br />
directory.<br />
All configuration data are inside this directory. When you install new version of software or<br />
uninstall the old version this directory will stay untouched. If you want to restore old data just<br />
overwrite this directory.<br />
26
Change language