InterLab System User Manual

1.6. HASP Key and Serial Number
InterLab System - User Manual
InterLab System is protected by HASP Key with software license and by Serial Number. User
needs them both to use InterLab System software.
HASP KEY
The software is protected by HASP (Hardware Assisted Software Protection) Key. This key is
provided as part of the software package and it contains the license for operating InterLab System.
The HASP Key must be plugged into an USB port on the computer that the software is resident on,
before you launch the application (during InterLab System installation) and the key must remain
in that place while the software is working. The software will only run on the computer that the
HASP Key is plugged into.
WARNING!
If you lose CD with software and documentation, it is possible to order a duplicate (copy of
CD). But if you lose HASP Key it results in complete loss of access rights to InterLab System
and you will not be issued with a replacement – there are no exceptions to this very clearly
stated rule.
SERIAL NUMBER
The Serial Number [Product Key] is a 16-digit unique number (in the format: YXXX-YXXX-
YXXX-YXXX where X is the digit and Y is a letter) applied to our product. The S/N is connected
with license for usage of the software and is registered in HASP Key.
The Serial Number is needed only once, during first launch of ilsPrintMaker on graphic station.
The software requires the user to enter a valid Serial Number to continue.
The number is located one HASP Key is delivered with attached information about Serial Number:
12