vehicle security system - Fusion

TROUBLE SHOOTING NOTES
PROBLEM POSSIBLE CAUSE ACTION
Remote only operates
central locking
Alarm arms itself Alarm is in passive
arming mode.
Unit is false alarming Faulty or poorly
installed pin / door
switches
Shock sensor is set
too sensitive
Alarm will not enter
valet mode
System in valet mode Turn off Valet mode
(pg8 operation
manual)
Ignition not turned on
or incorrectly wired
Vehicle will not start Engine disable
engaged
Alarm does not sound
when door is opened
Alarm will not sound
when the boot /
trunk is opened
Alarm will not sound
when the bonnet /
hood is opened
Alarm does not sound
when impact applied
Door switches not
operating or not
wired correctly
Trunk / Boot circuit
not connected
Bonnet / hood circuit
not connected
Shock sensor
adjusted incorrectly
Turn off passive
arming feature
(pg6 Installation
manual)
Check pin switch
installation, clean
factory door switches
Adjust shock sensor
settings
(pg8 Installation
manual)
Switch on ignition
before pushing the
valet button
Disarm alarm system
before starting
vehicle
Check wiring and
door switches
Check wiring
Check wiring
Adjust sensitivity
refer to shock sensor
(pg8 Installation
manual)
YOU CAN HELP PROTECT THE ENVIRONMENT!
Please remember to respect the local regulations:
Hand in the non-working electrical equipment
to an appropriate waste disposal center.
PUBLISHED BY FUSION ELECTRONICS LIMITED:
© Copyright 2007 by FUSION Electronics Limited.
All rights reserved. Specifications and design are
subject to change without notice.
12 13