road racing fim superbike & supersport world championships & fim ...

More documents

Recommendations

Info

Plates or crash bars from aluminium or steel also are permitted in addition to these covers. All these devices must be designed to be resistant against sudden shocks, abrasions and crash damage. FIM approved covers will be permitted without regard of the material. These covers must be fixed properly and securely with case cover screws that also mount the original covers/engine cases to the crankcases. The Technical Director has the right to forbid any cover, if the evidence shows the cover is not effective. 2.5.8.12 Transmission / Gearbox All transmission/gearbox ratios are free. The number of gears must remain as homologated. Primary gears must remain as homologated. Quick-shift systems are allowed. The layout of the transmission shafts must be the same as on the homologated motorcycle and only the material and the ratios can be changed. The layout and function of the shift drum must be the same as on the homologated motorcycle. The selector forks may be changed. However the forks must engage with the same gears and function in the same way as on the homologated motorcycle. Countershaft sprocket, rear wheel sprocket, chain pitch and size may be changed. Chain guard as long as it is not incorporated in the rear fender may be removed. 2.5.8.13 Clutch Clutch system (wet or dry type) and the method of operation (by cable or hydraulic) must remain as homologated. Friction and drive discs may be changed. 90 S S
Clutch springs may be changed. The clutch basket (outer) may be reinforced. The original clutch assembly may be modified or replaced by an aftermarket clutch, also including back torque limiting capabilities (slipper type). No power source (i.e. hydraulic or electric) can be used for gear selection, if not installed in the homologated model for <strong>road</strong> use. Human power is excluded from the ban. 2.5.8.14 Oil pumps, water pumps and oil lines Modifications are allowed but pump housing, mounting points and oil feed points must remain as original. Oil lines may be modified or replaced. Oil lines containing positive pressure, if replaced, must be of metal reinforced construction with swaged or treaded connectors. The internal parts of the water pump may be changed or modified. The drive ratio may be changed. The external appearance must remain as homologated. 2.5.8.15 Radiator / Oil cooler The radiator may be changed with an aftermarket radiator that fits in the standard location and does not require any modifications to the main frame or to the fairings’ outer appearance. Modifications to the homologated oil-cooler are allowed only they do not require any modifications to the main frame or to the fairings’ outer appearance. A heat exchanger (oil/water) may be replaced with an oil-cooler. Radiator fan and wiring may be changed, modified or removed. Additional oil coolers are not allowed. The oil cooler must not be mounted on or above the rear mudguard. 2.5.8.16 Air box The air box must remain as originally produced by the manufacturer on the homologated motorcycle. 91 S S
Page 1 and 2:
ROAD RACING FIM SUPERBIKE & SUPERSP
Page 3 and 4:
FEDERATION INTERNATIONALE DE MOTOCY
Page 5 and 6:
TABLE OF CONTENTS GENERAL UNDERTAKI
Page 7 and 8:
AMENDMENTS TO THE FIM ROAD RACING S
Page 9 and 10:
1. SPORTING REGULATIONS 1.1 INTRODU
Page 11 and 12:
h - The name, address and telephone
Page 13 and 14:
FIM Safety Officer Responsible for
Page 15 and 16:
1.5 INTERNATIONAL JURY 1.5.1 The ma
Page 17 and 18:
1.7 THE FIM STEWARDS 1.7.1 There wi
Page 19 and 20:
1.11 ENTRIES 1.11.1 Each team, must
Page 21 and 22:
The riders will be previously infor
Page 23 and 24:
1.13.2 The above schedule can only
Page 25 and 26:
1.15.3 Motorcycles 1.15.4 Lap time
Page 27 and 28:
1.16.2 Participants - Constant Wet
Page 29 and 30:
1.18.2 The length of a race may onl
Page 31 and 32:
Only one generator per motorcycle m
Page 33 and 34:
On returning to the grid the riders
Page 35 and 36:
The rider must respect the speed li
Page 37 and 38:
3) Riders should use only the track
Page 39 and 40:
1.23 PIT STOPS Any rider who exceed
Page 41 and 42:
• Yellow and Red Striped Flag The
Page 43 and 44: • Red Flag and Red Lights When th
Page 45 and 46: 1.26 FINISH OF A RACE AND RACE RESU
Page 47 and 48: 1.27.4 If the results calculated sh
Page 49 and 50: 1.30.3 For Constructors, only the h
Page 51 and 52: After the last control: - the winni
Page 53 and 54: 2) The 3 % nitric acid test (titani
Page 55 and 56: The Official Supplier shall provide
Page 57 and 58: As a first step, the weight handica
Page 59 and 60: Should the average value of ‘even
Page 61 and 62: The stickers will be handed to the
Page 63 and 64: • Electronically controlled throt
Page 65 and 66: If the air restrictor size is not u
Page 67 and 68: 2.4.8.7 Piston rings Piston rings m
Page 69 and 70: The number of gears must remain as
Page 71 and 72: • Ram air tubes or ducts running
Page 73 and 74: 2.4.10 Main frame and pre-assembled
Page 75 and 76: Holes may be drilled on the frame o
Page 77 and 78: 2.4.10.4 Rear suspension unit Rear
Page 79 and 80: Brake discs may be altered or repla
Page 81 and 82: Fuel tanks with tank breather pipes
Page 83 and 84: k) Material of construction of the
Page 85 and 86: • License plate bracket. • Tool
Page 87 and 88: At any time during the event, the w
Page 89 and 90: The tyres used in the free practice
Page 91 and 92: • Butterflies cannot be changed o
Page 93: 2.5.8.7 Piston rings Piston rings m
Page 97 and 98: 2.5.9 Electrics and electronics Ele
Page 99 and 100: Once the assembly of the replacemen
Page 101 and 102: 2.5.10.3 Rear fork (swing arm) The
Page 103 and 104: Front and rear brake pads may be ch
Page 105 and 106: g) The original air ducts into the
Page 107 and 108: 2.5.10.13 Rear Safety Light All mot
Page 109 and 110: Where breather or overflow pipes ar
Page 111 and 112: 2.6.5 Number plate colours The back
Page 113 and 114: During practices, qualifying sessio
Page 115 and 116: At the technical checks: for direct
Page 117 and 118: Clutch springs may be changed. 2.6.
Page 119 and 120: Central unit (ECU) may be relocated
Page 121 and 122: The sides of the frame-body may be
Page 123 and 124: Rear suspension linkage must remain
Page 125 and 126: Handlebars and hand controls may be
Page 127 and 128: g) The lower fairing must to be con
Page 129 and 130: • Instruments, instrument bracket
Page 131 and 132: Benzene % v/v 1.0 EN 238 RVP kPa 90
Page 133 and 134: 2.7.5 Fuel Sampling and Testing 1)
Page 135 and 136: The organiser must have fire exting
Page 137 and 138: In the inspection areas, under the
Page 139 and 140: If the helmet is clearly defective,
Page 141 and 142: Dry Superpole Each motorcycle which
Page 143 and 144: During practice days: From 08h30 un
Page 145 and 146:
2.11.6 Noise control Due to the sim
Page 147 and 148:
PRACTICE OR RACE N°: FIM ROAD RACI
Page 149 and 150:
SPORTS PRODUCTION C 145
Page 151 and 152:
NUMBERS/NUMEROS O 147
Page 153 and 154:
149
Page 155 and 156:
3. DISCIPLINARY AND ARBITRATION COD
Page 157 and 158:
- any corrupt or fraudulent act, or
Page 159 and 160:
3.3.4.2 Procedures The names of the
Page 161 and 162:
2. To the CDI against a decision of
Page 163 and 164:
Teams and riders contracted to comp
Page 165 and 166:
3.5.3 Witnesses and Experts 3.5.4 J
Page 167 and 168:
3.8 Law of Mercy The Management Cou
Page 169 and 170:
5. MEDICAL CODE 5.1 INTRODUCTION Th
Page 171 and 172:
• Can recommend to the Race Direc
Page 173 and 174:
Any rider, who, after treatment by
Page 175 and 176:
• Vehicles type A are to be place
Page 177 and 178:
• Equipment to immobilise limbs a
Page 179 and 180:
Medical Equipment: • Airway manag
Page 181 and 182:
• Vehicle(s) type C (number as pe
Page 183 and 184:
5.4 MEDICAL MALPRACTICE INSURANCE A
Page 185 and 186:
6. ANTI-DOPING CODE The regulations
Page 187 and 188:
TECHNICAL REGULATIONS APPENDIX 2013
Page 189 and 190:
• At the latest within 3 days bef
Page 191 and 192:
• Right side cover, Left side cov
Page 193 and 194:
• ABS installation and its compon
show all

road racing fim superbike & supersport world championships & fim ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?