LTCC PROCESSING INSTRUCTIONS For Ferro A6 and L8 Tape
LTCC PROCESSING INSTRUCTIONS For Ferro A6 and L8 Tape LTCC PROCESSING INSTRUCTIONS For Ferro A6 and L8 Tape
2.7 RESISTORS Technical Specification 87 Series Resistor System For A6 Tape Tolerance Hot TCR Cold TCR Resistor Type Ohms/square Specification (ppm/°C) (ppm/°C) FX 87-011 Buried 10 ±30% - - FX 87-011 Surface 10 ±30% - - FX 87-101 Surface 100 ±30% ±450 ±450 FX 87-101 Buried 100 ±30% ±450 ±450 FX 87-102 Surface 1000 ±30% ±200 ±200 FX 87-102 Buried 1000 ±30% ±200 ±200 FX 87-103 Surface 10,000 ±30% ±200 ±200 FX 87-103 Buried 10,000 ±30% ±200 ±200 Resistor Layout and Probe Area Layout
Resistor to conductor termination overlaps for surface and buried resistors Minimum Spacing Maximum Spacing Layout (mils) (mils) A 10 15 B 15 20 C 10 10
- Page 1 and 2: 1.1 UNREEL TAPE LTCC PROCESSING INS
- Page 3 and 4: ased stencils. A vacuum pull throug
- Page 5 and 6: no metallization, etc. Only minimum
- Page 7 and 8: L8 Tape Burn out & Firing Profile B
- Page 9 and 10: LTCC DESIGN RECOMMENDATIONS 2.1 CON
- Page 11 and 12: 2.2 GROUND AND POWER PLANES IC Bond
- Page 13 and 14: 2.4 ELECTRICAL VIAS Electrical via
- Page 15: Thermal Hexagonal Via Pattern: Six
2.7 RESISTORS<br />
Technical Specification 87 Series Resistor System <strong>For</strong> <strong>A6</strong> <strong>Tape</strong><br />
Tolerance Hot TCR Cold TCR<br />
Resistor Type Ohms/square Specification (ppm/°C) (ppm/°C)<br />
FX 87-011 Buried 10 ±30% - -<br />
FX 87-011 Surface 10 ±30% - -<br />
FX 87-101 Surface 100 ±30% ±450 ±450<br />
FX 87-101 Buried 100 ±30% ±450 ±450<br />
FX 87-102 Surface 1000 ±30% ±200 ±200<br />
FX 87-102 Buried 1000 ±30% ±200 ±200<br />
FX 87-103 Surface 10,000 ±30% ±200 ±200<br />
FX 87-103 Buried 10,000 ±30% ±200 ±200<br />
Resistor Layout <strong>and</strong> Probe Area Layout