UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
8.13 UV6048 Satellite Models<br />
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
The UV6048 Satellite models have been designed to allow two-way communication<br />
through the use of satellites.<br />
SATELLITE RECEIVER MODULE<br />
The satellite receiver module is a two-way communicator board that plugs into the card<br />
cage within the siren controller. The unit receives satellite signals and converts to RS232<br />
data and audio for delivery to the siren control module.<br />
The Lock LED will blink when the module receives a good signal. The receiver decodes<br />
audio from the satellite and provides an audio output that connects to the siren control<br />
board. The receiver provides a contact closure output that gates the 600-ohm audio<br />
input to the siren controller.<br />
LNB AMPLIFIER<br />
The LNB is a low noise block amplifier responsible for lowering the high frequencies in<br />
the satellite signals. The Uplink allows for the transmitting of signals from the siren to the<br />
AeroAstro web servers.<br />
DATA UPLINK<br />
The Receiver module also includes a Globalstar satellite uplink that transmits serial data<br />
from the siren controller back to the front end control point.<br />
UPLINK ANTENNA<br />
The Uplink antenna is a weather proof cabinet mounted LHCP antenna that transmits in<br />
the 1610 MHz range.<br />
AEROASTRO<br />
AeroAstro receives data packets from the Globalstar network and provides this data to<br />
the Federal Signal data web server over the internet. This server then forwards the data<br />
to the Commander siren control and status monitoring software.<br />
DTMF DECODER<br />
Local DTMF radio activation is done through the use of a 1-way receiver module within<br />
the UV controller.<br />
STROBE LIGHT<br />
A strobe light has been added to the siren to provide visual warning. Circuit protection for<br />
this light is provided through the use of a 6 Amp fuse on the UV motherboard.<br />
OPTIONS<br />
83