UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1.1 Introduction<br />
The <strong>UltraVoice</strong>+ controller is another<br />
Federal Signal innovation in siren<br />
control and battery operated<br />
amplification systems. A single highpowered<br />
computer based control board<br />
controls and monitors all siren functions<br />
minimizing wiring and increasing<br />
reliability. The modular <strong>UltraVoice</strong>+ siren<br />
controller replaces the previous Federal<br />
Signal MCP series of electronic siren<br />
controllers.<br />
Features<br />
Seven standard warning signals<br />
Up to 250 digitally stored voice<br />
messages – 1000 minutes total<br />
recording time (optional). Stored in<br />
removable FLASH card.<br />
Local pushbutton control<br />
8 remote contact closure inputs for<br />
activation<br />
Single tone, two-tone, DTMF, MSK,<br />
EAS & POCSAG decoders for<br />
remote siren control<br />
DTMF or MSK encoders for remote<br />
status monitoring<br />
600 I/O for wire line control and<br />
status monitoring<br />
Serial port control, for wire line<br />
control and status monitoring<br />
15A relay output<br />
Quiet Test - siren status monitoring<br />
Zoning - up to 8 zones per control<br />
cabinet for selective control of<br />
speaker outputs<br />
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
SECTION I<br />
GENERAL DESCRIPTION<br />
GENERAL DESCRIPTION<br />
8<br />
Power Control to ramp up siren<br />
volume for added safety and for low<br />
power testing<br />
Stackable siren functions enable<br />
user pre-defined warning scenarios<br />
Programmable radio receiver for Low<br />
Band, VHF, or UHF (optional)<br />
Windows R based siren programming<br />
software (optional)<br />
2 external transceiver ports or one<br />
external and one internal receiver<br />
VOX to provide carrier detect for<br />
primary transceiver port<br />
2 independent external serial ports<br />
Built in level meter to set and monitor<br />
receive level<br />
Real time battery voltage monitoring<br />
Programmable over wireless radio<br />
channel using SFCDWARE<br />
Modular design - no inter-board<br />
wiring, easy field service<br />
Programmable volume control<br />
The <strong>UltraVoice</strong>+ is designed around a<br />
card cage configuration. The card cage<br />
has a capacity of ten plug-in highly<br />
integrated cards consisting of: one<br />
controller position, one optional<br />
accessory position and eight amplifier<br />
positions. Each amplifier card consists<br />
of a 400-Watt amplifier designed to drive<br />
any combination of speaker drivers up<br />
to 400 Watts. Depending on the number<br />
of amplifier cards installed, eight power<br />
levels are available from 400 to 3200<br />
Watts.
Change language