UltraVoice Manual - Alerting & Notification

Federal Signal UltraVoice
Installation and Operation Manual
1 Sensor status is (0001), Bit 1 is 1, Amp 9 is bad or not active
Bit 2 is 0, Amp 10 is active and good
Bit 3 is 0, Amp 11 is active and good
Bit 4 is 0, Amp 12 is active and good
0 Sensor status is (1010), Bit 1 is 0, Battery is good
Bit 2 is 1, Master Current is not active
Bit 3 is 0, Signal B is active
Bit 4 is 1, Signal A is not active
> Sensor status is (1110), Bit 1 is 0, Intrusion has not occurred in cabinet 1
Bit 2 is 1, Not used
Bit 3 is 1, AC power is off
Bit 4 is 1, Charger is active
6 Sensor status is (0110), Bit 1 is 0, Rotation has occurred
Bit 2 is 1, Not used, input not active
Bit 3 is 1, Spare is not active
Bit 4 is 0, False alarm has occurred
; Terminating character
8.9 Solar Power Option
When purchased, the Solar option allows the siren to operate in areas where AC power
isn‟t available. Our PVS2110-24 model for the UltraVoice includes a solar regulator and
the solar panel kit. When installed, the batteries are charged by the battery charger via
the photovoltaic charging system providing operational power to the siren.
8.10 UV25ST Option
When purchased, the UV25ST allows the end-user the capability to reduce audio
output from the 70 VRMS standard to the 25 VRMS standard. This option is beneficial
when deploying the UltraVoice electronic controller in an indoor warning
application.
The UV25ST has a similar form and fit as the UV400 amplifier. In an indoor
application, the UltraVoice+ controller can accommodate up to (4) UV400
amplifiers and (4) UV25ST. For every UV400 amplifier utilized, a corresponding
UV25ST must be purchased.
The UV25ST plug into the unused amplifier slots following the UV400 amplifiers.
OPTIONS
78