UltraVoice Manual - Alerting & Notification

Amplifier status for each amp in
the unit depending on siren type*
Audio A*
Audio B*
Master Current*
Battery *
Charger
AC Power
Control Box Intrusion
Battery Box Intrusion
False Alarm/Local Activation*
Rotation*
* Latched Items -- remain set until
reception of a Reset command or
another function is run.
Status information is transmitted either
as a DTMF or FSK data string over the
communications channel and as an
ASCII string over the RS-232 port.
Report back transmission will occur
when one of two conditions exist:
1) Reception of a REPORT
command or
2) One of the asynchronous status
conditions changes state.
8.7 DTMF Report Format
Digit # Description
1 Start Character, always a DTMF “ * ”
2 Unit Type programmed into unit
(see Unit Type Definition)
3 Code Number Active most significant
digit (see Code Number Definition)
4 Code Number Active least significant
digit (see Code Number Definition)
5 Unit Number, BCD most significant digit
6 Unit Number, BCD middle digit
7 Unit Number, BCD least significant digit
8 Sensor Status, Amplifiers 1-4
Bit 1 = Amp 1
(Bit = 1 = Not Active)
Bit 2 = Amp 2
Federal Signal UltraVoice
Installation and Operation Manual
OPTIONS
73
Bit 3 = Amp 3
Bit 4 = Amp 4
9 Sensor Status, Amplifiers 5-8
Bit 1 = Amp 5
Bit 2 = Amp 6
Bit 3 = Amp 7
Bit 4 = Amp 8
10 Sensor Status, Amplifiers 9-12
Bit 1 = Amp 9
Bit 2 = Amp 10
Bit 3 = Amp 11
Bit 4 = Amp 12
11 Sensor Status
Bit 1 = Battery
(0 = Battery Okay)
Bit 2 = Master Current
(0 = At least one amp drawing
current)
Bit 3 = Audio B
(0 = Audio Present)
Bit 4 = Audio A
(0 = Audio Present)
12 Sensor Status
Bit 1 = Intrusion Cabinet 1
(0 = Door Closed)
Bit 2 = Not used
Bit 3 = AC Power
(0 = Ac Power On)
Bit 4 = Charger
(1 = Charger On)
13 Sensor Status
Bit 1 = Rotation
(0 = Rotation Occurred)
Bit 2 = Not Used
Bit 3 = Spare
(0 = Spare Closed)
Bit 4 = False Alarm
(0 = False alarm occurred)
14 Terminating Character, always a
DTMF “ * ”