UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2. Nominal base<br />
station TX level<br />
would be 1 Vp-p<br />
b. Adjust the level at TP16<br />
(2005698 controller card) for<br />
1 Vp-p<br />
i. REC gain adjustment<br />
R105(2005141 controller<br />
card front panel).<br />
1. Ensure tone is not<br />
clipped by viewing<br />
waveform with an<br />
oscilloscope.<br />
2. TX adjustment (If one way<br />
communication, then this step<br />
can be skipped)<br />
a. Simultaneously press buttons<br />
5 & 7 on the 2005698<br />
controller card. This will cause<br />
the controller to transmit for<br />
approximately 8 seconds.<br />
b. Determine proper siren TX<br />
level required.<br />
i. Nominal UV TX level<br />
would 1 Vp-p.<br />
ii. The TX levels for all of the<br />
siren controllers must be<br />
the same.<br />
1. Once one siren TX<br />
level is adjusted, all<br />
other sirens must<br />
be adjusted to the<br />
same level.<br />
a. Measured at the<br />
Base station.<br />
c. Adjust the TX level (2005698<br />
controller card front panel) for<br />
the correct level determined<br />
above.<br />
d. Ensure tone is not clipped or<br />
distorted by viewing waveform<br />
with oscilloscope.<br />
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
MAINTENANCE<br />
66<br />
7.6 600-Ohm Adjustment<br />
Procedure for External<br />
Audio Source Input<br />
Note: To use the 600 ohm input for<br />
external audio, at JP6 a jumper must<br />
be across pins 1-2. JP6 is located<br />
internally on the main controller card.<br />
1. Audio source adjustment for<br />
external audio source.<br />
a. Transmit a tone from the<br />
external audio source.<br />
i. Ensure tone is not<br />
clipped or distorted by<br />
viewing waveform with<br />
an oscilloscope.<br />
ii. Nominal external audio<br />
source level would be<br />
1 Vp-p.<br />
iii. If required adjust the<br />
external audio source.<br />
2. Audio source adjustment for UV<br />
controller.<br />
a. Transmit a tone from the<br />
external audio source<br />
b. Contact closure at JP15 pins<br />
10 and 11 (PTT: Push To<br />
Talk) is required to activate<br />
audio mode.<br />
c. Adjust the level using the<br />
external audio gain<br />
adjustment R123<br />
d. (R123 located internally on<br />
the 2005698 controller card<br />
circuit card).<br />
i. Preferred method of<br />
setting this level is to use<br />
a dB meter or by ear.<br />
1. Activate siren via<br />
external audio<br />
source.