UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
1.<br />
Customer:<br />
UV RTU Field Report<br />
Project Number: Date:<br />
Contact Person: Phone: Second Phone:<br />
Radio Shop: Contact: Phone:<br />
Siren Type: S/N: Voltage:<br />
Controller Type: Antenna: Omni<br />
Yagi<br />
CPU Software: Program file: SMV:<br />
PRE OPERATION CHECKOUT AND TEST<br />
58<br />
A/C Service: O.H.<br />
U.G.<br />
Radio Information: Low Band VHF UHF 800 Trunk 12.5 kHz 25 kHz<br />
Radio Frequency: TX RX PL<br />
Site: S/N: Address: Zone:<br />
A/C voltage: V AC Battery voltage: Charger voltage:<br />
Battery Type: Model: Manufacturer:<br />
Press buttons “2” & “3” on the CPU control board simultaneously. This will calibrate the speakers and amplifiers.<br />
Remove audio output lines from Amps 1-8 on the motherboard by pulling down on them. This will remove the speakers from the<br />
circuit.<br />
Select and execute the “ STEADY “ signal. Take RMS readings while unit is performing this function. When done recording readings<br />
cancel “STEADY” signal.<br />
Replace audio line to their appropriate location. Record impedance of each speaker driver.<br />
RMS VAC Impedance Sensor State<br />
Amp 1 VAC Amp 1 Intrusion Sensor Pass Fail<br />
Amp 2 VAC Amp 2 Low Battery Pass Fail<br />
Amp 3 VAC Amp 3 AC Power On Pass Fail<br />
Amp 4 VAC Amp 4 AC Power Off Pass Fail<br />
Amp 5 VAC Amp 5<br />
Amp 6 VAC Amp 6<br />
Amp 7 VAC Amp 7<br />
Amp 8 VAC Amp 8<br />
Descant in Control Cabinet: Yes<br />
No<br />
Antenna connectors sealed: Yes<br />
No<br />
Tested by: Date:<br />
Notes:<br />
Debris in Control Cabinet: Yes<br />
No
Change language