UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
JP5 Backplane<br />
48 pin EPT male card edge connector<br />
JP6 600 Ohm Input Configuration Jumper Pins:<br />
2-3 600 Ohm audio in to receiver decoders<br />
1-2 Audio from 600 Ohm sent to Amps<br />
when 600 Ohm PTT is closed<br />
JP7 600 Ohm Output Configuration Jumper Pins:<br />
1-2 Output siren audio<br />
2-3 Output radio transmit audio<br />
JP8 CTCSS Connector Pins:<br />
1 RX Audio in<br />
2 Ground<br />
3 8 VDC for CTCSS board<br />
4 Audio Switch<br />
5 TX CTCSS tone<br />
JP9 Transceiver #1 VOX Jumper<br />
Jumpered to use VOX for Carrier Detect<br />
JP10 Dual receiver priority jumper<br />
Jumper "EXT" side to give external receiver #1 priority<br />
Jumper "INT/EXT2" side to give on-board receiver or<br />
external receiver #2 priority.<br />
Jumper neither side, first carrier detect has priority<br />
JP11 Jumpered when SINAD option is used<br />
JP12 Short to force Carrier Detect of External transceiver 1<br />
JP13 External Transceiver Connector Pins<br />
Upper and Lower:<br />
1 RX Audio in<br />
Receive audio level for 300 m VP-P to 3<br />
VP-P to make 1 VP-P at TP16<br />
2 TX Audio out<br />
50 mVP-P to 3 VP-P<br />
3 Carrier Detect<br />
< 1 VDC for active<br />
4 PTT<br />
Active low, will sink 500 mA max.<br />
5,7 12 VDC for Radio<br />
+/- 0.2 Volts, 1.0 Amps max.<br />
6,8 Ground<br />
INSTALLATION<br />
43