UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
D. UVT6048 Inter-Cabinet Wiring<br />
1. Route 1” flexible conduit between<br />
the two (2) top cabinets.<br />
2. Route the supplied 22 AWG white<br />
wire attached to the charger (-)<br />
output in the secondary control<br />
through the conduit and butt splice<br />
or wire nut to the 22 AWG white<br />
wire attached to the charger (+)<br />
output in the primary control<br />
cabinet.<br />
3. Route both 22 AWG orange wires<br />
in the secondary control cabinet<br />
through the conduit to the primary<br />
control cabinet. Wire one orange<br />
wire from the secondary cabinet to<br />
JP15 position 4. Connect the other<br />
orange wire from the secondary<br />
cabinet to the orange wire coming<br />
from the intrusion switch in the<br />
primary battery cabinet with a butt<br />
splice or wire nut.<br />
4. Route the supplied six (6)<br />
conductor cable through the<br />
conduit and attach one end to<br />
JP18 of the primary control cabinet<br />
and the other to JP29 on the<br />
secondary control cabinet.<br />
5. Route the supplied 4 AWG black<br />
wire through the conduit and land<br />
on the (-) stud of both<br />
motherboards. Make sure the nuts<br />
are on tight taking care not to<br />
damage the motherboard.<br />
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
INSTALLATION<br />
41<br />
E. Battery Hookup<br />
DANGER<br />
When installing or removing batteries,<br />
take care to avoid shorting battery<br />
terminals to the metal battery cabinet.<br />
Failure to do so could result in serious<br />
personal injury or death. Batteries miswired<br />
can cause serious personal<br />
injury or death. Read and understand<br />
the following information before making<br />
actual connections.<br />
The end user must obtain batteries to<br />
install in the lower cabinet(s) as listed in<br />
the specifications section of this manual.<br />
Wire batteries as follows:<br />
1. Remove the accessory kit from the<br />
battery box.<br />
2. Connect the wires as shown in the<br />
appropriate system wiring diagram for<br />
the model of <strong>UltraVoice</strong> purchased;<br />
259024 (2-way models), 259025 (1way<br />
models), or 259027(UVT6048) as<br />
appropriate.<br />
3. Apply silicon grease to battery<br />
terminals after wiring to prevent<br />
corrosion.<br />
F. Optional Connections<br />
Refer to Section 8 for optional equipment<br />
connections and setup.<br />
See wiring diagram appendix B for field wiring of the 6048 models.