UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4.0 Control Unit<br />
The information in this section provides<br />
the user with guidelines necessary for<br />
installation.<br />
Control Unit mounting location must first<br />
be considered. The Control Unit can be<br />
mounted indoors as well as outdoors. In<br />
order to avoid losses in speaker power, it<br />
is recommended that the speaker array<br />
and Control Unit be installed without<br />
lengthening the 40-foot interconnecting<br />
cable supplied. If it is necessary to make<br />
a longer cable run, increasing the wire<br />
size of the entire cable to 12 AWG or<br />
larger is recommended.<br />
Whether the Control Unit is installed<br />
indoors or outdoors, it should be located<br />
out of the reach of vandals. Additionally,<br />
control and battery enclosures are both<br />
supplied with hasps for padlocking<br />
securely.<br />
The Control system requires a 120<br />
VAC or 240 VAC 50-60 Hz power<br />
source (model dependent).<br />
Several methods can be used to activate<br />
the Control Unit. The <strong>Manual</strong> activation<br />
switches can be used to activate the<br />
Control Unit locally. Landline control can<br />
be used through normally open contact<br />
switches. Connections should be made<br />
directly to the motherboard terminal<br />
block. The control can also be remotely<br />
activated via the optional radio receiver or<br />
an external 600 ohm audio source.<br />
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
SECTION IV<br />
SYSTEM PLANNING<br />
SYSTEM PLANNING<br />
29<br />
The total weights of the Control and<br />
Battery Box assemblies, including user<br />
provided batteries, are listed. Insure that<br />
the mounting surface and fasteners can<br />
safely sustain the weight of the assembly.<br />
Note that each UV400 amplifier must be<br />
added to obtain the total weight.<br />
Model No. Weight<br />
UV 170 lbs.<br />
UV400 4.12 lbs. each<br />
4.1 Siren and Control Location<br />
WARNING<br />
The sound output of the Modulator<br />
series speaker arrays is capable of<br />
causing permanent hearing damage.<br />
Do not install speaker arrays where<br />
persons may come within 150 feet of<br />
the direct path of the array.<br />
If speaker array is roof mounted, post<br />
warnings at all roof access points.<br />
Many factors affect the propagation of<br />
sound over various types of terrain and<br />
changing weather conditions. Consult<br />
FEMA CPG 1-17 and CPG 1-14 and your<br />
local Federal Signal representative to<br />
properly place your outdoor warning<br />
equipment.