UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
SECTION III<br />
ELECTRONIC SIREN CONTROL OPERATION<br />
3.0 Hardware General<br />
Description<br />
The modular <strong>UltraVoice</strong> Electronic<br />
Siren Controller contains a card<br />
cage with ten plug-in highly<br />
integrated boards consisting of:<br />
one controller slot, one optional<br />
accessory slot and eight amplifier<br />
slots. The number of amplifier<br />
cards can be varied from one for a<br />
400-watt system up to a maximum<br />
of eight for a 3200-watt system. All<br />
siren control, audio generation and<br />
remote communication functions<br />
are handled by a single<br />
3.1 <strong>Manual</strong> Activation<br />
ELECTRONIC SIREN CONTROL OPERATION<br />
25<br />
microcomputer controlled controller<br />
board. The back-plane<br />
(motherboard) contains connectors<br />
and terminal blocks for wireless<br />
interconnection of the other system<br />
components. To facilitate field<br />
service, no active circuitry is<br />
located on the back-plane. Power<br />
for the siren is supplied by 2 or 4<br />
deep cycle marine batteries. AC<br />
and Solar battery charger options<br />
are available.<br />
Located on the face of the controller, the manual activation switches are used to<br />
manually activate siren functions.<br />
Function Switch Function<br />
FUNC1 Activates functions under code 1<br />
FUNC2 Activates functions under code 2<br />
FUNC3 Activates functions under code 3<br />
FUNC4 Activates functions under code 4<br />
FUNC5 Activates functions under code 5<br />
FUNC6 Activates functions under code 6<br />
FUNC7 Activates functions under code 7<br />
FUNC8 Reset<br />
FUNC1 & FUNC6 Loads default speaker calibration values & transmits DTMF<br />
characters (production testing)<br />
FUNC2 & FUNC3 Calibrate speaker load & Xmit DTMF Quiet Test<br />
FUNC5 & FUNC7 Transmits 1200 Hz tone for radio deviation adjustment<br />
NOTE: At any time during a sounding function the "RESET" button may be<br />
pushed to cause the unit to halt all output immediately.