UltraVoice Manual - Alerting & Notification
UltraVoice Manual - Alerting & Notification UltraVoice Manual - Alerting & Notification
2.10 Expansion Slot I 2 C Federal Signal UltraVoice Installation and Operation Manual AUDIO A Audio present on channel A AUDIO B Audio present on channel B ARM Unit Armed indicator PA Public Address mode indicator CPU Microprocessor heartbeat CARRIER RF Carrier indicator ON w/carrier present RECEIVE LEVEL 3 stage LED bar graph The expansion slot contains the same connector pin-out as the Controller slot. Signals Available: Two I2C Ports 600 Ohm Balanced Port +5 VDC +24 VDC PTT AUDIO-A and AUDIO-B Open-Collector Output (for Rotator Relay) Charger Indicator 4 Remote Sensor Inputs 8 Remote Activation Inputs 4 Direction Sensor Inputs JP18 & JP19 5 VP-P + /- 1 V input 5 VDC + /- 0.2 V 250 mA Ground 250 mA maximum sink SPECIFICATIONS 22
2.12 Audio Output to Amplifiers Federal Signal UltraVoice Installation and Operation Manual Output voltage swing > 9VP-P + /- 3dB Maximum load 600 ohms Total harmonic distortion < 10% w/1 kHz sinewave Duty cycle (Built in signal generator) 1-255 seconds (user programmable) 2.13 Audio Power Amplifier Modules Model (UV400) Input voltage 24 VDC nominal 28 VDC maximum Input current siren mode @ 24 VDC w/1 kHz squarewave into 11 ohms: < 20 Amps Input current voice mode @24 VDC w/1 kHz tone set to 67 VRMS into 11 ohms: < 24 Amps Standby current at amps turned off < 10 mA Efficiency > 90% - siren mode > 80% - voice mode Output voltage into 11 ohms @1 kHz 67 VRMS nominal@ 400W - siren mode and 24 VDC nominal operating voltage 67 VRMS nominal@ 400W - voice mode Input impedance 100 k ohms A to D sensor accuracy < + /- 10% Audio distortion < 10% - voice mode – below clipping Frequency response + /- 3 dB, 300 - 3000 Hz Power low power mode < 5 Watts per amplifier Ripple on power supply w/all amps running at rated power in siren mode 0.5 VP-P maximum SPECIFICATIONS 23
- Page 1 and 2: UltraVoice tm Electronic Siren Cont
- Page 3 and 4: Federal Signal UltraVoice Installat
- Page 5 and 6: Federal Signal UltraVoice Installat
- Page 7 and 8: SECTION IX - APPENDIX A Federal Sig
- Page 9 and 10: Activation codes, command sequences
- Page 11 and 12: Site Address Switch: Unit Address T
- Page 13 and 14: Delay The delay function causes the
- Page 15 and 16: 2.0 Electrical Federal Signal Ultra
- Page 17 and 18: 2.4 Radio Communication Federal Sig
- Page 19 and 20: Federal Signal UltraVoice Installat
- Page 21: Controls: Federal Signal UltraVoice
- Page 25 and 26: Federal Signal UltraVoice Installat
- Page 27 and 28: functions programmed for that code,
- Page 29 and 30: 4.0 Control Unit The information in
- Page 31 and 32: Federal Signal UltraVoice Installat
- Page 33 and 34: 6. Drill a 3/8" pilot hole at each
- Page 35 and 36: 6. Install a user-supplied, fused,
- Page 37 and 38: Table 2 - MOD6048 Speaker Wiring Fe
- Page 39 and 40: Speaker Wiring for DSA Series Siren
- Page 41 and 42: D. UVT6048 Inter-Cabinet Wiring 1.
- Page 43 and 44: Federal Signal UltraVoice Installat
- Page 45 and 46: Federal Signal UltraVoice Installat
- Page 47 and 48: Federal Signal UltraVoice Installat
- Page 49 and 50: 5.4 Yagi Antenna Installation Yagi
- Page 51 and 52: Note A: Objects around the antenna
- Page 53 and 54: Federal Signal UltraVoice Installat
- Page 55 and 56: Federal Signal UltraVoice Installat
- Page 57 and 58: Federal Signal UltraVoice Installat
- Page 59 and 60: 7.0 General WARNING Service or main
- Page 61 and 62: C. Battery Check 1. The voltage of
- Page 63 and 64: 8. Turn service monitor to .25 V RF
- Page 65 and 66: 7.4 Adjustment Procedure for a Two-
- Page 67 and 68: Federal Signal UltraVoice Installat
- Page 69 and 70: 8.0 Radio Control The siren can be
- Page 71 and 72: instructions in the programming sof
2.12 Audio Output to Amplifiers<br />
Federal Signal <strong>UltraVoice</strong><br />
Installation and Operation <strong>Manual</strong><br />
Output voltage swing > 9VP-P + /- 3dB<br />
Maximum load 600 ohms<br />
Total harmonic distortion < 10% w/1 kHz sinewave<br />
Duty cycle (Built in signal generator) 1-255 seconds (user programmable)<br />
2.13 Audio Power Amplifier Modules Model (UV400)<br />
Input voltage 24 VDC nominal<br />
28 VDC maximum<br />
Input current siren mode @ 24 VDC w/1 kHz squarewave<br />
into 11 ohms: < 20 Amps<br />
Input current voice mode @24 VDC w/1 kHz tone set to 67 VRMS<br />
into 11 ohms: < 24 Amps<br />
Standby current at amps turned off < 10 mA<br />
Efficiency > 90% - siren mode<br />
> 80% - voice mode<br />
Output voltage into 11 ohms @1 kHz 67 VRMS nominal@ 400W - siren mode<br />
and 24 VDC nominal operating voltage 67 VRMS nominal@ 400W - voice mode<br />
Input impedance 100 k ohms<br />
A to D sensor accuracy < + /- 10%<br />
Audio distortion < 10% - voice mode – below clipping<br />
Frequency response + /- 3 dB, 300 - 3000 Hz<br />
Power low power mode < 5 Watts per amplifier<br />
Ripple on power supply w/all amps<br />
running at rated power in siren mode 0.5 VP-P maximum<br />
SPECIFICATIONS<br />
23