UltraVoice Manual - Alerting & Notification

More documents

Recommendations

Info

Audio A* Audio B* Master Current* Battery * Charger AC Power Control Box Intrusion Battery Box Intrusion False Alarm/Local Activation* Rotation* *Latched Items -- remain set until reception of a Reset command or another function is run. Federal Signal UltraVoice Installation and Operation Manual GENERAL DESCRIPTION 14 Status information is transmitted either as a DTMF or FSK data string over the communications channel and as an ASCII string over the RS232 port. Report back transmission will occur when one of two conditions exist: 1. Reception of a REPORT command or 2. One of the asynchronous status conditions changes state.
2.0 Electrical Federal Signal UltraVoice Installation and Operation Manual SECTION II SPECIFICATIONS Input Voltage 120 or 240 VAC 50 - 60 Hz* (*two separate models) Input Current 7 Amps maximum Battery Input Voltage 20-28 VDC 24 Volts (nominal) Battery Current 120 mA standby current, +18 - 22 Amps for each amplifier module running Maximum Signaling Time 30 minutes Stand By Time (with minimum 5-minute full signal reserve) Greater than 168 hours (7 days) without 2-way radio 2.1 Charger Current Limit Protected with automatic recovery EMI/RFI Filtering Meets FCC requirements Input 115 VAC (50 - 60 Hz), 3.5 A maximum Output Voltage 26 – 30 VDC (temperature compensated) Output Current 0 -10 Amps DC SPECIFICATIONS 15
Page 1 and 2: UltraVoice tm Electronic Siren Cont
Page 3 and 4: Federal Signal UltraVoice Installat
Page 7 and 8: SECTION IX - APPENDIX A Federal Sig
Page 9 and 10: Activation codes, command sequences
Page 11 and 12: Site Address Switch: Unit Address T
Page 13: Delay The delay function causes the
Page 17 and 18: 2.4 Radio Communication Federal Sig
Page 21 and 22: Controls: Federal Signal UltraVoice
Page 23 and 24: 2.12 Audio Output to Amplifiers Fed
Page 27 and 28: functions programmed for that code,
Page 29 and 30: 4.0 Control Unit The information in
Page 33 and 34: 6. Drill a 3/8" pilot hole at each
Page 35 and 36: 6. Install a user-supplied, fused,
Page 37 and 38: Table 2 - MOD6048 Speaker Wiring Fe
Page 39 and 40: Speaker Wiring for DSA Series Siren
Page 41 and 42: D. UVT6048 Inter-Cabinet Wiring 1.
Page 49 and 50: 5.4 Yagi Antenna Installation Yagi
Page 51 and 52: Note A: Objects around the antenna
Page 59 and 60: 7.0 General WARNING Service or main
Page 61 and 62: C. Battery Check 1. The voltage of
Page 63 and 64: 8. Turn service monitor to .25 V RF
Page 65 and 66:
7.4 Adjustment Procedure for a Two-
Page 67 and 68:
Federal Signal UltraVoice Installat
Page 69 and 70:
8.0 Radio Control The siren can be
Page 71 and 72:
instructions in the programming sof
Page 73 and 74:
Amplifier status for each amp in th
Page 75 and 76:
Example DTMF Report String Federal
Page 77 and 78:
Page 79 and 80:
8.11 FS-SINAD Option Federal Signal
Page 81 and 82:
Indicators Federal Signal UltraVoic
Page 83 and 84:
8.13 UV6048 Satellite Models Federa
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
ACTIVE MODULE 1 2 3 4 5 6 DRIVER- T
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111:
show all

UltraVoice Manual - Alerting & Notification

Create successful ePaper yourself

Delete template?

Save as template?