A History of Research and a Review of Recent Developments

References 181
7.41 Dancygier, A.N. and Yankelevsky, D.Z. (1994) Comparative penetration tests
of fibre reinforced concrete plates, Structures under Shock and Impact III, Comp.
Mech. Pub., June, p. 273.
7.42 Taylor, G.I. (1948) The formation and enlargement of a circular hole in a thin
plastic sheet, Quarterly Journal of Mechanics and Applied Maths, 1, p. 103.
7.43 Taylor, G.I. (no date) The use of flat ended projectiles for determining dynamic
yield stress, Proc. Roy. Soc. London, Vol. 194, Series A, p. 289.
7.44 Thomson, W.T. (1955) An approximate theory of armour penetration, Journal
of Applied Physics, 26(1), January.
7.45 Recht, R.F. and Ipson, T.W. (1963) Ballistic perforation dynamics, Journal of
Applied Mechanics, September.
7.46 Goldsmith, W. et al. (1965) Plate impact and perforation by projectiles,
Experimental Mechanics, December.
7.47 Backman, M.E. and Goldsmith, W. (1978) The mechanism of penetration of
projectiles into targets, Inter. Jour. Eng. Sci., 16, Pergamon Press, London.
7.48 Taylor, G.I. (1944) The Fragmentation of Tubular Bombs, Paper written for the
Advisory Council on Scientific Research and Technical Development, UK Ministry
of Supply.
7.49 Kinney, G. and Graham, K.J. (1985) Explosive Shocks in Air, Springer Verlag,
New York.
7.50 Ravid, M. and Bodner, S.R. (1983) Dynamic perforation of viseoelastic plates
by rigid projectiles, Int. Eng. Sci., 21, 577.
7.51 Goldsmith, W. and Finnegan, S.A. (1986) Normal and oblique impact of
cylinders—conical and cylindrical projectiles on metallic plates, Int. J. Impact
Engng, 4, p. 83.
7.52 Dehn, J. (1989) Mathematical models in penetration mechanics, Structures Under
Shock and Impact (1), Elsevier/C M Publications, p. 203.
7.53 Nurick, G.N. and Crowther, B.G. (1994) The measurement of the residual velocity
and deflection of a projectile passing through a thin plate, Structures Under
Shock and Impact (3), CM Publications, p. 261.
7.54 Wen, H.M. and Jones, N. (1992) Semi-empirical equations for the perforation
ofplates struck by a mass , Structures Under Shock and Impact (2), Thomas
Telford and CM Publications, p. 369.
7.55 Neilson, A.S. (1985) Empirical equations for the perforation of mild steel plates,
Int. J. Impact Eng., 3, p. 137.
7.56 Jowett, J. (1986) The Effect of Missile Impact on Thin Metal Structures, UKAEA
SRD R378.
7.57 Wen, H.M. and Jones, N. (1992) Experimental Investigation into the Dynamic
Plastic Response and Perforation of a Clamped Circular Plate Struck Transversely
by a Mass, Impact Res Centre ES/85/92, Dept of Mechanical Engineering,
University of Liverpool.
7.58 Gwaltney, R.C. (1968) Missile Generation and Protection in Light Water-cooled
Power Reactor Plants, Report URNL-USTC-22, Oak Ridge National Lab.,
Tennessee, USA.
7.59 Avery, J.G., Porter, T.R. and Lauzze, R.W. (1975) Structural integrity requirements
for projectile impact damage—an overview, Specialist meeting on Impact Damage
Tolerance of Structures, AGARD Conf. Proceedings, No. 186.
7.60 Mott, N.F. (1943) Fragmentation of H E Shells: a Theoretical Formula for the
Distribution of Weights of Fragments, UK Armament Research Department,
AC 3642 SD/FP85, March.
7.61 Mott, N.F. (1943) A Theory of Fragmentation of Shells and Bombs, UK Armament
Research Department, AC 4035, SD/FP 106, May.