Robinair 34700-2K 134a Recovery Unit - NY Tech Supply

More documents

Recommendations

Info

Operating Instructions 18 SLOW CHARGE PROCEDURE WARNING Before starting the vehicle's engine, verify that it is in PARK or NEUTRAL, with the emergency brake ON. Never run a vehicle without adequate ventilation in the work area. CAUTION! Close the high side manifold valve before starting the vehicle A/C system. 1. Close the High Side Valve. Put the Low Side Valve in the Recover/Vacuum position. 2. Start the vehicle, and set the AC system to its maximum setting. 3. Press START. The unit charges out of the low side inlet only, allowing the vehicle's compressor to pull the refrigerant into the A/C system. 4. When the unit is finished charging, the display reads: CHARGE COMPLETE X.XX lb (kg) CHARGED 5. Close the LOW SIDE manifold valve. 6. Turn off the vehicle's engine. 7. For R-134a systems, close the high and low side coupler valves. Remove the service hoses from the A/C system. The A/C system is now ready for use. © 2001 Robinair, SPX Corporation
REPLACING THE FILTER-DRIER Order part no. 34724 for a replacement filter-drier. The filterdrier on this unit is designed to trap acid and particulates, and is formulated to remove water from the refrigerant. You must change the filter-drier to ensure adequate moisture and contaminant removal. Typically, you can recycle up to 150 pounds (68 kilograms) of refrigerant between filter changes. CAUTION! For best results, use Robinair filterdriers (part no. 34724). All performance tests and claims are based on using this specially blended filter-drier. Use of another may affect performance results. 1. Press the MENU button. 2. Scroll through the menu to CHANGE FILTER and press START. 3. Press START again, and the unit will begin clearing the filter. 4. When clearing is complete, the display reads: TURN UNIT OFF AND REPLACE FILTER 5. Turn off the main power, and unplug the machine. 6. Open the unit door, and replace the old filter with the new filter. 7. Close the unit door, plug in the machine, and turn on the Main Power. The filter change is now complete. 34700-2K/17700-2K Cool-Tech Recovery/Recycling/Recharging Unit Maintenance Instructions MAIN POWER BREAKER CONTROL BREAKER Filter-Drier Location of the Filter-Drier OUNCES MLS 12 340 11 320 300 10 280 9 260 8 240 220 7 200 6 180 160 5 140 4 120 100 3 80 2 60 40 1 20 INST0478 Filter Drier INST0948 19
Page 1 and 2: ○ ○ ○ ○ ○ ○ ○ ○ ○
Page 3 and 4: Introduction ......................
Page 5 and 6: HIGH LOW Diagram of Unit’s Compon
Page 7 and 8: INITIAL SETUP CAUTION! R-134a syste
Page 9 and 10: USING THE SELECTION MENU 34700-2K/1
Page 11 and 12: SELECTING A UNIT (METRIC/ENGLISH) 1
Page 13 and 14: OPERATING TIPS 34700-2K/17700-2K Co
Page 15 and 16: INST0699 34700-2K/17700-2K Cool-Tec
Page 17 and 18: NOTE: It is not necessary to change
Page 19: RECHARGING THE A/C SYSTEM WARNING W
Page 23 and 24: CHECKING FOR LEAKS 34700-2K/17700-2
Page 25 and 26: 34700-2K 17700-2K R-134a R-12 Repla
Page 27 and 28: 34700-2K/17700-2K Cool-Tech Recover
Page 29 and 30: 34700-2K/17700-2K Cool-Tech Recover
Page 32: CONVERSION TABLE OZ. LBS. 0.5 0.03

Robinair 34700-2K 134a Recovery Unit - NY Tech Supply

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?