Morley Fire Panels Installation Manual - Smiths Technical Systems
Morley Fire Panels Installation Manual - Smiths Technical Systems
Morley Fire Panels Installation Manual - Smiths Technical Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ZX <strong>Fire</strong> Alarm Control <strong>Panels</strong> MORLEY-IAS<br />
7.10 External Wiring Connections<br />
• Refer to the following sections of this manual for information regarding the connection of<br />
detection loop cables, sounder circuits and other site installation wiring and cabling:<br />
1. Detection Loops – Section 3.4.3<br />
2. Sounder Circuits - Section 3.4.4<br />
3. Auxiliary Relay Outputs – Section 3.4.5<br />
4. Auxiliary Supply Outputs - Section 3.4.6<br />
5. Panel Networking / Graphics PC Interface – Section 3.4.7<br />
6. Peripheral Loop – Section 3.4.8<br />
7. RS485 Wiring Arrangements – Section 3.4.9<br />
8. High Integrity Loop – Section 3.4.10<br />
9. Recommended Cables – Section 3.4.13<br />
7.11 Cable Routing<br />
• Cables should be routed within the enclosure in accordance with the diagram below.<br />
AC Mains<br />
Cables<br />
RS485/RS232<br />
Power-Limited<br />
SLC Circuits<br />
Power-Limited<br />
Figure 37 – Recommended Cable Routing Arrangement – ZX10Se<br />
Sounder and<br />
AUX Power<br />
Power-Limited<br />
Relay Outputs<br />
Non Power-Limited<br />
Inter-panel RS485<br />
Network wiring<br />
Relay Outputs<br />
Non Power-Limited<br />
<strong>Installation</strong> <strong>Manual</strong> Document No. 996-174-000-1, Revision: 01 Page 47