Morley Fire Panels Installation Manual - Smiths Technical Systems
Morley Fire Panels Installation Manual - Smiths Technical Systems
Morley Fire Panels Installation Manual - Smiths Technical Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MORLEY-IAS ZX <strong>Fire</strong> Alarm Control <strong>Panels</strong><br />
7 Appendix - ZX10Se <strong>Installation</strong><br />
7.1 General<br />
• The ZX10Se FACP has been designed to offer a solution to providing up to ten loops of fire<br />
detectors without the need to install the panels in different locations on site. Two ZX5Se FACPs<br />
are networked together within one large back box with provision for up to four 17Ah batteries to<br />
be fitted. Depending on the configuration, the batteries either can be fitted inside the ZX10Se<br />
backbox or, when a large capacity is required, these can be installed in adjacently-located<br />
battery boxes (797-077).<br />
• The ZX10Se contains two PSUs and each must be provided with separate, mains supply wiring<br />
from separate isolators.<br />
7.2 Warnings and Cautions<br />
• Refer to Section 1.2 Warnings and Cautions before carrying out any procedures described in this<br />
manual.<br />
7.3 National Approvals<br />
• Refer to Section 1.3 National Approvals for details of equipment compliance requirements.<br />
7.4 Unpacking<br />
• Refer to 2 Unpacking for details of what equipment should have been supplied with the ZX10Se.<br />
7.5 <strong>Installation</strong><br />
• Refer to the procedure described in Section 3.1 Installing the Enclosure and Section 3.1.2<br />
Mounting the Enclosure to the Wall for details of removing the internal equipment prior to<br />
installing the ZX10Se enclosure.<br />
• Refer to Section 3.1.3 Remounting the Chassis for details of re-fitting the ZX5Se FACPs in the<br />
enclosure.<br />
Page 42 Document No. 996-174-000-1, Revision: 01 <strong>Installation</strong> <strong>Manual</strong>