Morley Fire Panels Installation Manual - Smiths Technical Systems

ZX Fire Alarm Control Panels MORLEY-IAS
Specification Item Values
Enclosure 500mm wide, 500mm high, 183 mm deep.
Sealed to IP30.
Weight 19 kg without batteries.
Operating Temperature 0°C to +40°C
38.8 kg with 24Ah batteries fitted.
Relative Humidity 85% (non-condensing)
Knockouts (20mm) 24 (Top), 24 (Bottom)
Sounder Output 4 programmable outputs.
Open- and short-circuit monitored.
6k8, EOL resistors (P/N 170-073-682).
1A maximum output current.
Minimum switched current – 1mA.
Auxiliary Relay 2 volt-free, changeover outputs. Relay 1 configured as Fault
output. Relay 2 configured as Fire output.
Contacts rated at 30V AC/DC, 1 Amp maximum.
Minimum switched load – 1mA @ 5V
Sensor Circuit 1 to 5 plug-in loop driver modules per panel.
Supports Analogue Addressable devices over a 2-wire,
combined-power and digital-data, transmission loop.
Loop Output Voltage and Signalling depends on the loop
driver installed – refer to documentation supplied with the
loop driver.
Maximum Loop Loading is 460mA per loop.
Monitoring zones Up to 20 zones with individual LED indicators, expandable to
40 / 80 zones with optional LED indicator boards.
Maximum 120 zones – up to 200 software zones (no LED
indicators).
Table 10 – ZX5Se Functional Specifications
Installation Manual Document No. 996-174-000-1, Revision: 01 Page 39